單項選擇題

Refer to the exhibit. What can be determined about the router from the console output?()

A.No configuration file was found in NVRAM.
B.No configuration file was found in flash.
C.No configuration file was found in the PCMCIA card.
D.Configuration file is normal and will load in 15 seconds.


您可能感興趣的試卷

你可能感興趣的試題

1.單項選擇題What is the most efficient summarization that R1 can use to advertise its networks to R2()。

A.172.1.0.0/22
B.172.1.0.0/21
C.172.1.4.0/22
D.172.1.4.0/24 172.1.5.0/24 172.1.6.0/24 172.1.7.0/24
E.172.1.4.0/25 172.1.4.128/25 172.1.5.0/24 172.1.6.0/24 172.1.7.0/24

2.多項選擇題Which two statements describe the Cisco implementation of VLANs? ()

A.VLAN 1 is the default Ethernet VLAN.
B.CDP advertisements are only sent on VLAN 1002.
C.By default, the management VLAN is VLAN 1005.
D.By default, the switch IP address is in VLAN 1005.
E.VLAN 1002 through 1005 are automatically created and cannot be deleted.

3.單項選擇題

The user of Host1 wants to ping the DSL modem/router at 192.168.1.254. Based on the Host1 ARP table that is shown in the exhibit, what will Host1 do()。

A.send a unicast ARP packet to the DSL modem/router
B.send unicast ICMP packets to the DSL modem/router
C.send Layer 3 broadcast packets to which the DSL modem/router responds
D.send a Layer 2 broadcast that is received by Host2, the switch, and the DSL modem/router

4.多項選擇題What are three characteristics of the OSPF routing protocol? ()

A.It converges quickly.
B.OSPF is a classful routing protocol.
C.It uses cost to determine the best route.
D.It uses the DUAL algorithm to determine the best route.
E.OSPF routers send the complete routing table to all directly attached routers.
F.OSPF routers discover neighbors before exchanging routing information.

5.單項選擇題A router has learned three possible routes that could be used to reach a destination network. One route is from EIGRP and has a composite metric of 20514560. Another route is from OSPF with a metric of 782.The last is from RIPv2 and has a metric of 4. Which route or routes will the router install in the routing table?()

A.Router R2 will not form a neighbor relationship with R1.
B.Router R2 will obtain a full routing table, including a default route, from R1.
C.R2 will obtain OSPF updates from R1, but will not obtain a default route from R1.
D.R2 will not have a route for the directly connected serial network, but all other directly connected

最新試題

請參見圖示。主機A 正在訪問多臺服務器。結合使用什么端口號和地址即可唯一識別特定服務器上運行的特定進程?()

題型:單項選擇題

請參見圖示。網絡中的所有設備均使用默認配置。此拓撲中需要多少個邏輯地址范圍?()

題型:單項選擇題

請參見圖示。在網絡中,PC1向PC2發送了一條消息。PC2收到的幀如圖所示。該幀中的哪一信息確定了正確的目的應用程序?()

題型:單項選擇題

請參見圖示。網絡中的主機A 正在向主機B 發送數據段。有關所交換的數據段的流量控制如圖所示。下列關于此通信的陳述,哪兩項是正確的?()

題型:多項選擇題

請參見圖示。圖中所示路由表所屬的PC 已正確配置。IP 地址192.168.1.254屬于哪一個網絡設備或接口?()

題型:單項選擇題

傳輸層如何讓主機能同時針對不同應用程序維護多個通信流?()

題型:單項選擇題

請參見圖示。RouterB 已經過正確配置。RouterA 的以太網接口Fa0/0已使用如圖所示的命令進行配置。但是,從RouterA 的Fa0/0接口無法成功ping 通RouterB 的Fa0/0接口。應在RouterA 上采取什么措施來解決此問題?()

題型:單項選擇題

請參見圖示。下列哪組設備僅包含中間設備?()

題型:單項選擇題

請參見圖示。對于從主機A 向Web 服務器發出的網頁請求,正確的目的套接字數字是什么?()

題型:單項選擇題

請參見圖示。主機A 嘗試與主機C 建立TCP/IP 會話。在嘗試期間,路由器Y 的FastEthernet 接口fa0/1捕獲到一個幀。捕獲的幀中包含源IP 地址為172.16.1.5而目的IP 地址為172.16.7.24的數據包。捕獲該幀時,它的源MAC 地址是什么?()

題型:單項選擇題