單項選擇題

Host1的用戶想PING DSL調制解調器/路由器的192.168.1.254，ARP表如下圖，Host1會怎么操作？（）

A.發送一個單播ARP包到DSL調制解調器/路由器
B.發送一個單播ICMP包到DSL調制解調器/路由器
C.發送三層廣播包到響應的DSL調制解調器/路由器
D.發送一個可以被Host2，the switch，and the DSL modem/router 受到的2層廣播幀


您可能感興趣的試卷

你可能感興趣的試題

1.單項選擇題A medium-sized company has a Class C IP address. It has two Cisco routers and one non-Cisco router. All three routers are using RIP version 1. The company network is using the block of 198.133.219.0/24. The company has decided it would be a good idea to split the network into three smaller subnets and create the option of conserving addresses with VLSM. What is the best course of action if the company wants to have 40 hosts in each of the three subnets?（）

A.Convert all the routers to EIGRP and use 198.133.219.32/27, 198.133.219.64/27, and 198.133.219.92/27 as the new subnetworks.
B.Maintain the use of RIP version 1 and use 198.133.219.32/27, 198.133.219.64/27, and 133.219.92/27 as the new subnetworks.
C.Convert all the routers to EIGRP and use 198.133.219.64/26, 198.133.219.128/26, and 133.219.192/26 as the new subnetworks.
D.Convert all the routers to RIP version 2 and use 198.133.219.64/26, 198.133.219.128/26, and 133.219.192/26 as the new subnetworks.
E.Convert all the routers to OSPF and use 198.133.219.16/28, 198.133.219.32/28, and 198.133.219.48/28 as the new subnetworks.
F.Convert all the routers to static routes and use 198.133.219.16/28, 198.133.219.32/28, and

2.單項選擇題Which command shows your active Telnet connections？（）

A.show session
B.show cdp neighbors
C.show users
D.show queue

3.單項選擇題What is the purpose of the command shown below vtp password Fl0r1da（）。

A.It is used to validate the sources of VTP advertisements sent between switches.
B.It is used to access the VTP server to make changes to the VTP configuration.
C.It allows two VTP servers to exist in the same domain, each configured with different passwords.
D.It is the password required when promoting a switch from VTP client mode to VTP server mode.
E.It is used to prevent a switch newly added to the network from sending incorrect VLAN information to the other switches in the domain.

4.單項選擇題What is an appropriate use of a default route?（）

A.to provide routing to a local web server
B.to provide routing from an ISP to a stub network
C.to provide routing that will override the configured dynamic routing protocol
D.to provide routing to a destination that is not specified in the routing table and which is outside the local network

5.多項選擇題What are two reasons a network administrator would use CDP (Choose two.)（）。

A.to verify the type of cable interconnecting two devices
B.to determine the status of network services on a remote device
C.to obtain VLAN information from directly connected switches
D.to verify Layer 2 connectivity between two devices when Layer 3 fails
E.to obtain the IP address of a connected device in order to telnet to the device
F.to determine the status of the routing protocols between directly connected routers

最新試題

請參見圖示。電纜1和電纜2分別按照特定的物理層要求接線。哪三個網段使用電纜2？（）

題型：多項選擇題

OSI 模型的哪兩項功能在第2層實現？（）

題型：多項選擇題

請參見圖示。一臺路由器（其路由表如圖所示）收到發往192.168.1.4的數據包。路由器將如何處理該數據包？（）

題型：單項選擇題

請參見圖示。主機A 嘗試與主機C 建立TCP/IP 會話。在嘗試期間，路由器Y 的FastEthernet 接口fa0/1捕獲到一個幀。捕獲的幀中包含源IP 地址為172.16.1.5而目的IP 地址為172.16.7.24的數據包。捕獲該幀時，它的源MAC 地址是什么？（）

題型：單項選擇題

請參見圖示。一臺主機正使用NAT 連接到Internet。下列哪三項IP 地址可實現此連接？（）

題型：多項選擇題

請參見圖示。網絡中的所有設備均使用默認配置。此拓?fù)渲写嬖诙嗌賯€廣播域？（）

題型：單項選擇題

何時必須使用clock rate 命令配置路由器串行接口？（）

題型：單項選擇題

請參見圖示。哪種邏輯拓?fù)涫菍D示網絡的準確描述？（）

題型：單項選擇題

請參見圖示。某用戶想要查看當前的配置。圖中所示為ipconfig/all 命令的輸出。從此輸出可以得到哪三項結論？（）

題型：多項選擇題

請參見圖示。網絡中的所有設備均使用默認配置。此拓?fù)渲行枰嗌賯€邏輯地址范圍？（）

題型：單項選擇題