Which routing protocols will support the following IP addressing scheme? ()
Network 1 - 192.168.10.0 /26
Network 2 - 192.168.10.64 /27
Network 3 - 192.168.10.96 /27
Network 4 - 192.168.10.128 /30
Network 5 - 192.168.10.132 /30
A.RIP version 1
B.RIP version 2
C.IGRP
D.EIGRP
E.OSPF
您可能感興趣的試卷
你可能感興趣的試題
A.Layer2
B.Layer3
C.Layer4
D.Layer5
E.Layer6
F.Layer7
A.By default, all defined VLANs are allowed on the trunk.
B.Each single VLAN, or VLAN range, must be specified with the switchport mode command.
C.Each single VLAN, or VLAN range, must be specified with the vtp domain command.
D.Each single VLAN, or VLAN range, must be specified with the vlan database command.
A.PVST+reduces the CPU cycles for all the switches in the network
B.PVST+automatically selects the root bridge location,to provide optimiz…
C.PVST+allow the root switch location to be optimized per vlan.
D.PVST+supports Layer 3 load balancing without loops.
A.It is supplied by the CSU/DSU.
B.It is supplied by the far end router.
C.It is determined by the clock rate command.
D.It is supplied by the Layer 1 bit stream timing.
Refer to the diagram. Which three statements describe the router port configuration and the switch port configuration as shown in the topology? ()
A.The Router1 WAN port is configured as a trunking port.
B.The Router1 port connected to Switch1 is configured using subinterfaces.
C.The Router1 port connected to Switch1 is configured as 10 Mbps.
D.The Switch1 port connected to Router1 is configured as a trunking port.
E.The Switch1 port connected to Host B is configured as an access port.
F.The Switch1 port connected to Hub1 is configured as full duplex.
最新試題
OSI 模型的哪兩項功能在第2層實現?()
請參見圖示。圖中所示路由表所屬的PC 已正確配置。IP 地址192.168.1.254屬于哪一個網絡設備或接口?()
請參見圖示。主機B 嘗試與主機C 建立TCP/IP 會話。在嘗試期間,San Francisco 器由器的FastEthernet 接口fa0/1捕獲到一個幀。捕獲的幀中包含源IP 地址為10.10.1.2而目的IP 地址為10.31.1.20的數據包。捕獲該幀時,它的目的MAC 地址是什么?()
請參見圖示。網絡中的所有設備均使用默認配置。此拓?fù)渲行枰嗌賯€(gè)邏輯地址范圍?()
請參見圖示。網絡中的主機A 正在向主機B 發送數據段。有關所交換的數據段的流量控制如圖所示。下列關于此通信的陳述,哪兩項是正確的?()
請參見圖示。一臺主機正使用NAT 連接到Internet。下列哪三項IP 地址可實現此連接?()
在Cisco IOS 設備中,啟動配置文件存儲于何處?()
PC 無法連接到任何遠程網站,無法ping 通其默認網關,也無法ping 通本地網段中工作正常的打印機。以下哪項操作可以確認此PC 上的TCP/IP 協議棧是否工作正常?()
請參見圖示。主機X 和主機Y 與本地網絡的通信受到限制。此問題的原因是什么?()
請參見圖示。從主機X 發出的到主機Y 的tracert 命令已成功。下列哪一項正確地反映了追蹤列表中顯示的中間網絡設備的順序?()