A.Filtering can occur based on Layer 3 information.
B.Broadcasts are eliminated.
C.Routers generally cost less than switches.
D.Broadcasts are not forwarded across the router.
E.Adding a router to the network decreases latency.
您可能感興趣的試卷
你可能感興趣的試題
A.The PC has connectivity with a local host.
B.The PC has connectivity with a Layer 3 device.
C.The PC has a default gateway correctly configured.
D.The PC has connectivity up to Layer 5 of the OSI model.
E.The PC has the TCP/IP protocol stack correctly installed.
A.It creates a global address pool for all outside NAT transactions.
B.It establishes a dynamic address pool for an inside static address.
C.It creates dynamic source translations for all inside local PAT transactions.
D.It creates a one-to-one mapping between an inside local address and an inside global address.
E.It maps one inside source address to a range of outside global addresses.
A.VLAN support
B.compression
C.authentication
D.sliding windows
E.multilink support
F.quality of service
A.It specifies use of a static encryption key that must be changed frequently to enhance security.
B.It requires use of an open authentication method.
C.It specifies the use of dynamic encryption keys that change each time a client establishes a connection.
D.It requires that all access points and wireless devices use the same encryption key.
E.It includes authentication by PSK
A.Configure a separate sub-interface for each PVC with a unique DLCI and subnet assigned to the sub-interface.
B.Configure each Frame Relay circuit as a point-to-point line to support multicast and broadcast traffic.
C.Configure many sub-interfaces on the same subnet.
D.Configure a single sub-interface to establish multiple PVC connections to multiple remote router interfaces.
最新試題
Which name describes an IPV6 host-enable tunneling technique that uses IPV4 UDP,does not require dedicated gateway tunnels,and can pass through existing IPV4 NAT gateways?（）
A network administrator is trying to add a new router into an established OSPF network.The networks attached to the new router do not appear in the routing tables of the other OSPF routers.Given the information in the partial configuration shown below,what configuration error is causing this problem?（）Router(config)#router ospf 1Router(config-router)#network 10.0.0.0 255.0.0.0 area 0
Which pairing reflects a correct protocol-and-metric relationship?（）
When you are troubleshooting an ACL issue on a router,which command can help you to verify which interfaces are affected by the ACL?（）
Which address is the IPV6 all-RIP-routers muticast group address that is used by RIPng as the destaion address?（）
What is the result of issuing the frame-relay map ip 192.168.1.2 202 broadcast command?（）
Which command is used to display the collection of OSPF link states?（）
Which cisco ios command can help to determine the timing of various debug events,relative to each other,when you are debugging a complicated router issue?（）
Which command displays the CHAP authentication process as it occurs between two routers?（）
The network administrator cannot to switch 1 over a telnet session,although the hosts attached to switch 1 can ping the interface Fa0/0 of the router.Given the information in the graphic and assuming that the router and switch2 are configured properly,which of the following commands should be issued on switch 1 to correct this problem?（）