A.Layer 2
B.Layer 3
C.Layer 4
D.Layer 5
E.Layer 6
F.Layer 7
您可能感興趣的試卷
你可能感興趣的試題
A.By default， all defined VLANs are allowed on the trunk.
B.Each single VLAN， or VLAN range， must be specified with the switchport mode command.
C.Each single VLAN， or VLAN range， must be specified with the vtp domain command.
D.Each single VLAN， or VLAN range， must be specified with the vlan database command.
A.It is supplied by the CSU/DSU.
B.It is supplied by the far end router.
C.It is determined by the clock rate command.
D.It is supplied by the Layer 1 bit stream timing.
A.A WPA key is longer and requires more special characters than the WEP key.
B.The access point and the client are manually configured with different WPA key values.
C.WPA key values remain the same until the client configuration is changed.
D.The values of WPA keys can change dynamically while the system is used.
A.The router will use the static route.
B.The router will use the OSPF route.
C.The router will use the EIGRP route.
D.The router will load balance and use all three routes.
A.neighbor table
B.SPF table
C.RTP table
D.topology table
E.query table
F.DUAL table
最新試題
Which address is the IPV6 all-RIP-routers muticast group address that is used by RIPng as the destaion address?（）
What is the subnetwork address for a host with the IP address 201.100.5.68/28?（）
Which pairing reflects a correct protocol-and-metric relationship?（）
Three switches are connected to one anther via trunk ports.Assuming the default switch configuration,which switch is elected as the root bridge for the spanning-tree instance of vlan 1?（）
What is the result of issuing the frame-relay map ip 192.168.1.2 202 broadcast command?（）
Which name describes an IPV6 host-enable tunneling technique that uses IPV4 UDP,does not require dedicated gateway tunnels,and can pass through existing IPV4 NAT gateways?（）
At which layer of the OSI model is RSTP used to prevent loops?（）
While troubleshooting a network problem,a technician discovers that the current copy of the Cisco IOS is outdated and needs to be updated.Which of the following commands would the technician issue to replace the Cisco router IOS with the newer version?（）
Which cisco ios command can help to determine the timing of various debug events,relative to each other,when you are debugging a complicated router issue?（）
Which Cisco IOS diagnostics command can disrupt the operation of a router under high-load conditions?（）