Refer to the exhibit.What two results would occur if the hub were to be replaced with a switch that is configured with one Ethernet VLAN?()
A.The number of collision domains would decrease.
B.The number of collision domains would increase.
C.The number of broadcast domains would remain the same.
D.The number of collision domains would remain the same.
E. The number of broadcast domains would increase.
您可能感興趣的試卷
你可能感興趣的試題
Refer to the graphic.Host A is communicating with the seiver. What will be the source MAC address of the frames received by Host A from the server?()
A.the MAC address of the seiver network interface
B.the MAC address of host A
C.the MAC address of router interface e 1
D.the MAC address of router interface e0
A.The transport layer divides a data stream into segments and may add reliability and flow control information.
B.The data link layer adds physical source and destination addresses and an FCS to the segment.
C.Packets are created when the network layer encapsulates a frame with source and destination host addresses and protocol-related control information.
D.Packets are created when the network layer adds Layer 3 addresses and control information to a segment.
E.The presentation layer translates bits into voltages for transmission across the physical link.
A. session
B. network
C. Physical
D. data link
E. Transport
A. application
B. presentation
C. session
D. transport
E. internet
F. data link
Refer to the exhibit, Host A pings interface S0/0 on router 3, what is the TTL value for that ping?()
A. 253
B. 252
C. 255
D. 254
最新試題
Which three features are added in SNMPv3 over SNMPv2? ()
Which three are the components of SNMP? ()
What command visualizes the general NetFlow data on the command line?()
Which statement describes the process ID that is used to run OSPF on a router ?()
What Cisco IOS feature can be enabled to pinpoint an application that is causing slow network performance?()
What are two benefits of using a single OSPF area network design?()
Refer to the exhibit.If the router Cisco returns the given output and has not had its router ID set manually, what value will OSPF use as its router ID?()
Syslog was configured with a level 3 trap. Which 3 types of logs would be generated?()
What are the benefit of using Netflow?()
What command instructs the device to timestamp Syslog debug messages in milliseconds?()