A.Designated Root Cost
B.bridge ID priority
C.max age
D.bridge ID MAC address
E.Designated Root Priority
F.forward delay
您可能感興趣的試卷
你可能感興趣的試題
A.one global STP instance for all VLANs
B.one STP instance for each VLAN
C.one STP instance per set of VLANs
D.one STP instance per set of bridges
A.Attempt to TELNET from the router connected to the inside of the firewall to the router connected to the outside of the firewall.If telnet works,BGP will work,since telnet and BGP both use TCP to transport data
B.Ping from the router connected to the inside interface of the firewall to the router connected to the outside interface of the firewall.If you can ping between them,BGP should work,since BGP uses IP to transport packets
C.There is no way to make BGP work across a firewall without special configuration,so there is no simple test that will show you if BGP will work or not,other than trying to start the peering session
D.There is no way to make BGP work across a firewall
A.The TTL field from the IP packet is copied into the TTL field of the MPLS label header at the ingress edge LSR
B.TTL propagation cannot be disabled in an MPLS domain
C.TTL propagation is only disabled on the ingress edge LSR
D.The TTL field of the MPLS label header is set to 255
E.The TTL field of the IP packet is set to 0
A.Cisco IOS IPS enabled on the untrusted interface
B.NBAR enabled to perform protocol discovery and deep packet inspection
C.a route map to define the trusted outgoing traffic
D.a route map to define the application inspection rules
E.an inbound extended ACL applied to the untrusted interface
最新試題
What is the three main step of using the QoS feature with MQC command line interface?
SPT初始狀態之后的一個狀態是什么?
Which of the following describes the roles of devices in a WAN?()
four switches, which one will be root switch.(no pic).
什么是NAT?
Which of the following are key characteristics of PPP?()
一堆交換機一個server、一個transpare,問配置prune在哪里配置?
What is the next state of initial in spanning-tree protocol?
Refer to the exhibit.What is the meaning of the term dynamic as displayed in the output of the show frame-relay map command shown?()
What field in IP packet is used for classification by QOS?