Refer to the exhibit.The network administrator normally establishes a telnet session with the switch from host A.However,host A is unavailable.The administrator′s attempt to the switch from host B fails,but pings to the other two hosts are successful.what is the issue?()
A.Host B and the switch need to be in the same subnet.
B.The switch needs and appropriate default gateway assigned.
C.The switch interface connected to the router is down.
D.Host B need to be assigned an IP address in vlan 1.
E.The switch interfaces need the appropriate IP addresses assigned.
您可能感興趣的試卷
你可能感興趣的試題
A.it is a layer 2 messaging protocol which maintains vlan configurations across network.
B.it includes an 8-bit field which specifies the priority of a frame.
C.it is used exclusively for tagging vlan frames and dose not address network reconvergence following switched network topology changes.
D.it modifies the 802.3 frame header,and thus requires that the FCS be recomputed.
E.it is a trunking protocol capable of carring untagged frames.
Based on the network shown in the graphic which option contains the potential networking problem and protocol or setting that can to prevent the problem?()
A.Routing loops, hold down timers
B.Switching loops, split horizon
C.Routing loops, split horizon
D.Switching loops, VTP
E.Routing loops, STP
F.Switching loops, STP
A.ping address
B.tracert address
C.traceroute address
D.arp address
A.added security
B.dedicated bandwidth
C.provides segmentation
D.allows switches to route traffic between subinterfaces
E.contains collisions
Refer to the exhibit. Which statement is true?()
A.The Fa0/11 role confirms that SwitchA is the root bridge for VLAN 20.
B.VLAN 20 is running the Per VLAN Spanning Tree Protocol.
C.The MAC address of the root bridge is 0017.596d.1580.
D.SwitchA is not the root bridge, because not all of the interface roles are designated.
最新試題
What OSPF command, when configured, will include all interfaces into area 0?()
Which three features are added in SNMPv3 over SNMPv2? ()
Which three features are added in SNMPv3 over SNMPv2 ? ()
What authentication type is used by SNMPv2?()
What is the default Syslog facility level?()
Which is true about OSPF router-id?()
Which statement describes the process ID that is used to run OSPF on a router ?()
In a GLBP network, who is responsible for the arp request?()
Which three statements about the features of SNMPv2 and SNMPv3 are true?()
Refer to the exhibit.If the devices produced the given output,what is the cause of the EtherChannel problem?()