A.it enables PIM BSR
B.it makes the router an Auto-RP mapping agent
C.it advertises the router as an RP with Auto-RP
D.it makes the router an Auto-RP client
您可能感興趣的試卷
你可能感興趣的試題
A.It will send the join only to the neighbor with the highest IP address.
B.It will send the join only to the neighbor with the lowest IP address.
C.It will send the join in a round-robin fashion across all neighbors.
D.It will send the join to all neighbors.
A.2001：db8：3811：：1
B.2001：db8：3811：：2323
C.2001：db8：3811：：0130
D.2001：db8：3811：：3
E.2001：db8：3811：：6
A.Flooding paths and redundancy
B.Amount of routing information in the OSPF area or routing domain
C.Number of routers with Cisco Express Forwarding enabled
D.Number of neighbor adjacencies
E.Other routing protocols in use
F.OSPF timer reconstruction negotiation
G.Redistribution with BGP neighbors
H.Redistribution with other IGP routing protocols， such as RIP or EIGRP
A. BGP peers must be Layer 2-adjacent
B. EBGP multihop is not configured
C. The firewall is not configured to allow IP protocol 89
D. The firewall is not configured to allow UDP 179.
Refer to the exhibit. Users on the 199.155.24.0 network are unable to reach the 172.16.10.0 network. What is the most likely solution？（）
A. Router ISP1 should be configured to peer with router B
B. Router ISP2 should be configured with no synchronization
C. Router ISP1 should be configured with no synchronization
D. Router ISP2 should be configured with no auto-summary.
E. Router ISP1 or IPS2 should be configured with network 176.16.10.0 mask 255.255.255.0
最新試題
When STP UplinkFast is enabled on a switch utilizing the default bridge priority， what will the new bridgepriority be changed to？（）
In order to configure two routers as anycast RPs， which of these requirements， af a minimum， must besatisfied？（）
Which of these best describes the actions taken when a VTP message is received on a switch configuredwith the VTP mode "transparent"？（）
Choose two commands that are required to enable multicast on a router， when it is known that thereceivers use a specific functionality of IGMPv3.（）
The classic Spanning Tree Protocol （802.1 D 1998） uses which sequence of variables to determine thebest received BPDU？（）
Based on the exhibit presented. What will be the objective of this route map when applied to traffic passing through a router？（）
Which protocol and port have been assigned by IANA for RADIUS authentication？（）
In PIM-SM what control plane signaling must a multicast source perform before it begins to send multicasttraffic to a group？（）
You are the network administrator of an enterprise with a main site and multiple remote sites. Your networkcarries both VOIP and data traffic. You agree with your service provider to classify VOIP and data trafficaccording to the different service RFCs. How can your data and VOIP traffic be marked？（）
Which multicast address is reserved for cisco-rp-discovery？（）