多項選擇題If IP routing is enabled, which two commands set the gateway of last resort to the default gateway?()

A. ip default-gateway 0.0.0.0
B. ip route 172.16.2.1 0.0.0.0 0.0.0.0
C. ip default-network 0.0.0.0
D. ip default-route 0.0.0.0 0.0.0.0 172.16.2.1
E. ip route 0.0.0.0 0.0.0.0 172.16.2.1


您可能感興趣的試卷

你可能感興趣的試題

1.多項選擇題Workstation A has been assigned an IP address of 192.0.2.24/28. Workstation B has been assigned an IP address of 192.0.2.100/28. The two workstations are connected with a straight-through cable. Attempts to ping between the hosts are unsuccessful. What two things can be done to allow communications between the hosts? ()

A. Replace the straight-through cable with a crossover cable.
B. Change the subnet mask of the hosts to /25.
C. Change the subnet mask of the hosts to /26.
D. Change the address of Workstation A to 192.0.2.15.
E. Change the address of Workstation B to 192.0.2.111.

2.多項選擇題Which two addresses can be assigned to a host with a subnet mask of 255.255.254.0?()

A.113.10.4.0
B.186.54.3.0
C.175.33.3.255
D.26.35.2.255
E.17.35.36.0

3.單項選擇題The network default gateway applying to a host by DHCP is 192.168.5.33/28.Which option is the valid IP address of this host?()

A.192.168.5.55
B.192.168.5.47
C.192.168.5.40
D.192.168.5.32
E.192.168.5.14

4.單項選擇題Cisco Catalyst switches CAT1 and CAT2 have a connection between them using ports FA0/13.An 802.1Q trunk is configured between the two switches.On CAT1,VLAN10 is chosen as native,but on CAT2 the native VLAN is not specified.What will happen in this scenario?()

A.802.1Q giants frames could saturate the link.
B.VLAN10 on CAT1 and VLAN1 on CAT2 will send untagged frames.
C.A native VLAN mismatch error message will appear.
D.VLAN10 on CAT1 and VLAN1 on CAT2 will send tagged frames.

5.單項選擇題Which command shows system hardware and software version information?()

A.show configuration
B.show environment
C.show inventory
D.show platform
E.show version

最新試題

What is the purpose of the cisco Vlan Trunking protocol?()

題型:?jiǎn)雾?xiàng)選擇題

When you are troubleshooting an ACL issue on a router,which command can help you to verify which interfaces are affected by the ACL?()

題型:?jiǎn)雾?xiàng)選擇題

Which cisco ios command can help to determine the timing of various debug events,relative to each other,when you are debugging a complicated router issue?()

題型:?jiǎn)雾?xiàng)選擇題

How are VTP advertisements delivered to switches across the network?()

題型:?jiǎn)雾?xiàng)選擇題

An employee of ABC company has move to an office on a different floor. Although the administrator is able to telnet to all of the routers,the address of Switch F is needed in order to verify that the employee remains in the same VLAN.Which action could be used by the administrator to find the IP address of Switch F?()

題型:?jiǎn)雾?xiàng)選擇題

Which statement describes the rule of split horizon?()

題型:?jiǎn)雾?xiàng)選擇題

Which device might be installed at a branch office to enable and manage an IPsec site-to-site VPN?()

題型:?jiǎn)雾?xiàng)選擇題

What is the default administrative distance of OSPF?()

題型:?jiǎn)雾?xiàng)選擇題

A network administrator is planning a network installation for a large organization.The design requires 100 separate subnetworks,so the company has acquired a Class B network address.What subnet mask will provide the 100 subnetworks required, if 500 usable host addresses are required per subnet?()

題型:?jiǎn)雾?xiàng)選擇題

The network administrator cannot to switch 1 over a telnet session,although the hosts attached to switch 1 can ping the interface Fa0/0 of the router.Given the information in the graphic and assuming that the router and switch2 are configured properly,which of the following commands should be issued on switch 1 to correct this problem?()

題型:?jiǎn)雾?xiàng)選擇題