A.STP root status
B.VTP mode
C.Negotiation status
D.Management domain
E.Configuration revision number
您可能感興趣的試卷
你可能感興趣的試題
A.Devices use DHCP to request their VLAN.
B.Attached devices are unaware of any VLANs.
C.Devices are assigned to VLANs based on their MAC addresses.
D.Devices are in the same VLAN regardless of which port they attach to.
A.VMPS server lookup is required
B.Easy to configure
C.Easy of adds，moves，and changes
D.Based on MAC address of the connected device
Given the above partial configuration, which two statements are true about VLAN traffic?（）
A.VLANs 1-5 will use fa0/10 as a backup only.
B.VLANs 6-10 will use fa0/10 as a backup only.
C.VLANs 1-5 will be blocked if fa0/10 goes down.
D.VLANs 1-10 are configured to load share between fa0/10 and fa0/12.
E.VLANs 6-10 have a port priority of 128 on fa0/10.
A.Configuration revision number
B.Configuration revision flag field
C.Configuration revision reset switch
D.Configuration revision database
E.None of the other alternatives apply
A.VLAN 1003
B.VLAN 1
C.VLAN ON
D.VLAN A
E.VLAN 0
最新試題
What two things will occur when an edge port receives a BPDU？（）
Which router redundancy protocol cannot be configured for interface tracking？（）
Refer to the exhibit. Based on the output of the show spanning-tree command， which statement is true？ （）
If G1/0/1 on DS1 is shutdown， what will be the current priority value of the Vlan105’s group on DS1 ？（）
During routine maintenance， it became necessary to shutdown G1/0/1 on DS1 and DS2. All other interface were up. During this time， DS1 became the active device for Vlan104’s HSRP group. As related to Vlan104’s HSRP group. What can be done to make the group function properly ？ （）
What will occur when a nonedge switch port that is configured for Rapid Spanning Tree does not receive a BPDU from its neighbor for three consecutive hello time intervals？（）
Which two statements are true when the extended system ID feature is enabled？ （）
Which two statements about the various implementations of STP are true？（）
Refer to the exhibit. LACP has been configured on Switch1 as shown. Which is the correct command set to configure LACP on Switch2？（）
What must be the same to make multiple switches part of the same Multiple Spanning Tree （MST）？（）