單項選擇題The network administrator has discovered that the power supply has failed on a switch in the company LAN and that the switch has stopped functioning. It has been replaced with a Cisco Catalyst 2950 series switch. What must be done to ensure that this new switch becomes the root bridge on the network?()

A. Lower the bridge priority number.
B. Change the MAC address of the switch.
C. Increase the VTP revision number for the domain.
D. Lower the root path cost on the switch ports.
E. Assign the switch an IP address with the lowest value.


您可能感興趣的試卷

你可能感興趣的試題

1.單項選擇題Which command shows if an access list is assigned to an interface?()

A. show ip interface [interface] access-lists
B. show ip access-lists interface [interface]
C. show ip interface [interface]
D. show ip access-lists [interface]

2.單項選擇題A wireless client cannot connect to an 802.11b/g BSS with a b/g wireless card. The client section of the access point does not list any active WLAN clients. What is a possible reason for this?()

A. The incorrect channel is configured on the client.
B. The client's IP address is on the wrong subnet.
C. The client has an incorrect pre-shared key.
D. The SSID is configured incorrectly on the client.

3.單項選擇題What occurs on a Frame Relay network when the CIR is exceeded?()

A. All TCP traffic is marked discard eligible.
B. All UDP traffic is marked discard eligible and a BECN is sent.
C. All TCP traffic is marked discard eligible and a BECN is sent.
D. All traffic exceeding the CIR is marked discard eligible.

4.單項選擇題A network administrator must configure 200 switch ports to accept traffic from only the currently attached host devices. What would be the most efficient way to configure MAC-level security on all these ports?()

A. Visually verify the MAC addresses and then telnet to the switches to enter the switchport-port security mac-address command.
B. Have end users e-mail their MAC addresses. Telnet to the switch to enter the switchport-port security mac-address command.
C. Use the switchport port-security MAC address sticky command on all the switch ports that have end devices connected to them.
D. Use show mac-address-table to determine the addresses that are associated with each port and then enter the commands on each switch for MAC address port-security.

5.單項選擇題What is the difference between a CSU/DSU and a modem?()

A. A CSU/DSU converts analog signals from a router to a leased line; a modem converts analog signals from a router to a leased line.
B. A CSU/DSU converts analog signals from a router to a phone line; a modem converts digital signals from a router to a leased line.
C. A CSU/DSU converts digital signals from a router to a phone line; a modem converts analog signals from a router to a phone line.
D. A CSU/DSU converts digital signals from a router to a leased line; a modem converts digital signals from a router to a phone line.

最新試題

At which layer of the OSI model is RSTP used to prevent loops?()

題型:?jiǎn)雾?xiàng)選擇題

Which Cisco IOS diagnostics command can disrupt the operation of a router under high-load conditions?()

題型:?jiǎn)雾?xiàng)選擇題

Which encapsulation type is a Frame Relay encapsulation type that is supported by Cisco routers?()

題型:?jiǎn)雾?xiàng)選擇題

Which statement is true, as relates to classful or classless routing?()

題型:?jiǎn)雾?xiàng)選擇題

Which statement describes the rule of split horizon?()

題型:?jiǎn)雾?xiàng)選擇題

Which device might be installed at a branch office to enable and manage an IPsec site-to-site VPN?()

題型:?jiǎn)雾?xiàng)選擇題

Which command encrypts all plaintext passwords?()

題型:?jiǎn)雾?xiàng)選擇題

Which protocol reduces administrative overhead in a switched network by allowing the configuration of a new VLAN to be distributed to all the switches in a domain?()

題型:?jiǎn)雾?xiàng)選擇題

The network administrator cannot to switch 1 over a telnet session,although the hosts attached to switch 1 can ping the interface Fa0/0 of the router.Given the information in the graphic and assuming that the router and switch2 are configured properly,which of the following commands should be issued on switch 1 to correct this problem?()

題型:?jiǎn)雾?xiàng)選擇題

A network administrator needs to configure a serial link between the main office and a remote location.The router at the remote office is a non-cisco router. How should the network administrator configure the serial interface of the main office router to make the connection?()

題型:?jiǎn)雾?xiàng)選擇題