單項選擇題Which statement is true about the configuration of AutoQoS on a Frame Relay interface?()

A.AutoQoS can be configured from a different subinterface if the DLCI is already assigned to one subinterface 
B.Multilink PPP (MLP) over Frame Relay must be manually configured on low speed DLCIs 
C.for low-speed Frame Relay DLCIs with Frame Relay-to ATM interworking, the AutoQoS cannot be configured if a virtual template is already configured for the DLCI 
D.AutoQoS can be configured on a Frame Relay DLCI only if a map class is attached to the DLCI 


您可能感興趣的試卷

你可能感興趣的試題

1.單項選擇題

Refer to the exhibit. What type of interface will connect the voice gateway router R1 to the analog phone and the fax machine?()

A.the analog phone will be connected to the FXS port, and the fax machine will be connected to the FXO port on router R1
B.the analog phone will be connected to the FXO port, and the fax machine will be connected to the FXS port on router R1
C.both devices will be connected to the FXS port on router R1
D.both devices will be connected to the FXO port on router R1
E.both devices will be connected to the E and M ports on router R1

2.單項選擇題Which statement is true about the capabilities of a voice gateway router?()

A.voice gateways with analog interfaces need a gatekeeper to convert analog signals into digital format before voice is encapsulated into IP packets
B.voice gateways need a gatekeeper to interconnect the VoIP networks the PSTN network
C.voice gateways with Cisco Unified CallManager Express (CME) can permanently act as a call agent for IP phones
D.voice gateways equipped with a DSP module can take the role of the call agent during WAN failure.

3.單項選擇題A GRE tunnel is configured between a local and a remote site. Where should the service policy be applied to classify packets based on the pretunnel header? ()

A.in global configuration mode, apply the service policy and use the qos pre-classify
B.in global configuration mode, apply the service policy but do not use the qos pre-classify command
C.apply the service policy on the physical interface but do not use the qos pre-classify
D.apply the service policy on the tunnel interface but do not use the qos pre-classify command 
E.apply the service policy on the tunnel interface and use the qos pre-classify command

4.多項選擇題What are two of the three predefined classes for the Cisco SDM wizard?()

A.business-critical 
B.high priority 
C.middle class
D.voice
E.best effort
F.scavenger

5.多項選擇題Which two statements are true about the application of QoS in a converged network?()

A.end-to-end network delay times that exceed 50 ms for real-time traffic are considered unacceptable
B.end-to-end network delay times that exceed 250 ms for real-time traffic are considered unacceptable
C.end-to-end network delay is not a factor as long as the  delay is consistent
D.some packet loss can be corrected by codec algorithms
E.RSVP handles voice packet retransmission
F.fragmentation is a result of packet loss

最新試題

Which statement is true about the Call Admission Control (CAC) feature in VoIP networks?()

題型:單項選擇題

What are three factors used to determine the amount of bandwidth that is required for a single VoIP call? ()

題型:多項選擇題

Which set of classes correctly identifies the four traffic classes, from highest priority to lowest priority, specified in the 802.11e standard?()

題型:單項選擇題

What are the three models of quality of service (QoS) in a network?()

題型:多項選擇題

SDM creates a low latency queuing (LLQ) service policy with its associated classes. What are the two types of low latency queuing available using the SDM QoS wizard?()

題型:多項選擇題

Which two functions can be provided by an Integrated Services Router (ISR) in a VoIP network?()

題型:多項選擇題

Which three functions can an Integrated Services Router perform in a VoIP network?()

題型:多項選擇題

Which two commands should be entered on a WLAN controller to remove any residual configuration?()

題型:單項選擇題

Which two characteristics are common between traffic policing and traffic shaping?()

題型:多項選擇題

What is the term that is used to describe the process of converting a signal from digital to analog?()

題型:單項選擇題