A. you can apply multiple access lists with the same protocol or in different direction.
B. you can config one access list,per direction,per layer 3 protocol
C. you can place as many access lists as you want on any interface
D. you can apply only one access list on any interface
您可能感興趣的試卷
你可能感興趣的試題
A. spanning-tree mode rapid-pvst
B. spanning-tree uplinkfast
C. spanning-tree backbonefast
D. spanning-tree mode mst
A. they run a spell check on host names to ensure accurate routing
B. they map individual hosts to their specific IP address
C. they convert domain names into IP address
D. Given an IP address,they determine the name of the host that is…
A. Flash,TFTP server,ROM
B. Flash,NVRAM,ROM
C. ROM,NVRAM,TFTP server
D. NVRAM,TFTP server,ROM
E. TFTP server,Flash,NVRAM
A. show session
B. show cdp neighbors
C. show users
D. show queue
A. transport type all
B. transport output all
C. transport preferred all
D. transport input all
最新試題
Three access ports have been installed and configured to a small office.What term defines the wireless topology?（）
While troubleshooting a network problem,a technician discovers that the current copy of the Cisco IOS is outdated and needs to be updated.Which of the following commands would the technician issue to replace the Cisco router IOS with the newer version?（）
What is the result of issuing the frame-relay map ip 192.168.1.2 202 broadcast command?（）
The network administrator cannot to switch 1 over a telnet session,although the hosts attached to switch 1 can ping the interface Fa0/0 of the router.Given the information in the graphic and assuming that the router and switch2 are configured properly,which of the following commands should be issued on switch 1 to correct this problem?（）
How are VTP advertisements delivered to switches across the network?（）
A router receives information about network 192.168.10.0/24 from multiple sources.What will the router consider the most reliable information about the path to that network?（）
Which cisco ios command can help to determine the timing of various debug events,relative to each other,when you are debugging a complicated router issue?（）
Which pairing reflects a correct protocol-and-metric relationship?（）
If all OSPF routers in a single area are configured with the same priority value,what value dose a router use for the ODPF router ID in the absence of a loopback interface?（）
A network administrator is trying to add a new router into an established OSPF network.The networks attached to the new router do not appear in the routing tables of the other OSPF routers.Given the information in the partial configuration shown below,what configuration error is causing this problem?（）Router(config)#router ospf 1Router(config-router)#network 10.0.0.0 255.0.0.0 area 0