A network administrator is trying to add a new router into an established OSPF network.The networks attached to the new router do not appear in the routing tables of the other OSPF routers.Given the information in the partial configuration shown below,what configuration error is causing this problem?（）Router(config)#router ospf 1Router(config-router)#network 10.0.0.0 255.0.0.0 area 0

On which options are standard access list based?（）

Which device might be installed at a branch office to enable and manage an IPsec site-to-site VPN?（）

Which name describes an IPV6 host-enable tunneling technique that uses IPV4 UDP,does not require dedicated gateway tunnels,and can pass through existing IPV4 NAT gateways?（）

Which encapsulation type is a Frame Relay encapsulation type that is supported by Cisco routers?（）

Three switches are connected to one anther via trunk ports.Assuming the default switch configuration,which switch is elected as the root bridge for the spanning-tree instance of vlan 1?（）

Which command encrypts all plaintext passwords?（）

Three access ports have been installed and configured to a small office.What term defines the wireless topology?（）

An employee of ABC company has move to an office on a different floor. Although the administrator is able to telnet to all of the routers,the address of Switch F is needed in order to verify that the employee remains in the same VLAN.Which action could be used by the administrator to find the IP address of Switch F?（）

When you are troubleshooting an ACL issue on a router,which command can help you to verify which interfaces are affected by the ACL?（）