A.SDMVoice
B.SDMSignal
C.SDMTrans
D.SDMManage
E.SDMRout
F.SDMBulk
您可能感興趣的試卷
你可能感興趣的試題
A.Traffic bursts are smoothed out by queuing the excess traffic to produce a steadier flow of data
B.Excess traffic is buffered so that the traffic remains within the desired rate.
C.Packets that conform to traffic policies are not delayed.
D.Packet marking is available and allows excess packets to be re-marked with a lower priorit
A.Queuing introduces equal delays for packets of the same flow, resulting in jitter.
B.When congestion occurs, dropping affects most of the TCP sessions, which simultaneously back off and then restart again.
C.All buffers can temporarily be seized by aggressive flows, and normal TCP flows experience buffer starvation.
D.There is no differentiated drop mechanism. Higher priority traffic is dropped in the same way as best-effort traffic.
E.In TCP starvation, traffic exceeds the queue limit because of the bursty nature of packet networks. A router cannot handle multiple concurrent TCP sessions.
F.Global synchronization occurs because multiple TCP hosts reduce their transmission rates at random intervals in response to packet dropping
A. If the classification policy is based upon the ToS byte, the qos pre-classify command is required because the ToS byte only appears in the inner IP header.
B. The ToS byte is copied to the outer header by default. Therefore, the qos pre-classify command is not necessary.
C. With GRE encapsulation, the qos pre-classify command is applied on the tunnel interface. This practice allows for different OoS configurations on each tunnel.
D. With GRE encapsulation, the qos pre-classify command is applied on the physical interface. This practice allows for different OoS configurations on each interface.
E. With IPsec encapsulation, the qos pre-classify command is applied on the physical interface. This practice allows for different OoS configurations on each interface.
A. In a Frame Relay network, delay sensitive traffic is tagged with the discard eligible (DE) bit.
B. In an MPLS network, the three most significant bits of the DSCP or the IP precedence of the IP packet are copied into the MPLS EXP field
C. In an MPLS network, the MPLS EXP bits are used to identify up to 16 CoS values.
D. The differentiated services code point (DSCP) field consists of the first three bits of the IP precedence field in the header of an IP packet.
E. The 802.10 standard uses a three bitfield referred to as the user priority bits (PRI) to mark packets as belonging to a specific CoS.
Refer to the exhibit. Which two statements accurately describe the pictured WPA wireless LAN controller configuration?()
A.WPA1 is disabled and WPA2 is enabled.
B.WPA1 is enabled and WPA2 is disabled.
C.WPA1 is enabled and WPA2 is enabled.
D.TKIP is the default parameter for WPA1 andWPA2.
E.AES is the default parameter for WPA1 and WPA2.
F.The default WPA1 and WPA2 parameters are enabled
最新試題
What are three factors used to determine the amount of bandwidth that is required for a single VoIP call? ()
For delay sensitive traffic, what are the three best ways that are used to prevent packet loss? ()
Which three user interfaces exist for the Cisco WLAN Controllers?()
Within the WMM policy, how many default QoS radio access categories are there?()
Which set of classes correctly identifies the four traffic classes, from highest priority to lowest priority, specified in the 802.11e standard?()
End-to-end QoS is maintained in the Cisco WLAN deployment model by utilizing what parameter in lieu of 802.1p?()
What can be used to maintain the voice quality on a link by limiting the number of calls that can be active at any given time?()
Which two commands should be entered on a WLAN controller to remove any residual configuration?()
What are three Cisco Unified CallManager features? ()
Which three functions are associated with a Cisco Unified CallManager? ()