A. Use CBWFQ to queue the peer-to-peer traffic into the default traffic class.
B. Use class-based WRED to randomly drop the peer-to-peer traffic during network congestions.
C. Use class-based policing to limit the peer-to-peer traffic rate.
D. Use class-based shaping to delay any excessive peer-to-peer traffic.
您可能感興趣的試卷
你可能感興趣的試題
A. source port
B. output interface
C. next-hop IP address
D. source MAC address
E. destination IP address
F. next-hop MAC address
A. intrusion protection
B. identity
C. secure connectivity
D. security management
A. Easy VPN
B. IPsec GRE tunneling
C. Virtual Tunnel Interfaces
D. Dynamic Multipoint VPN
A. 1
B. 2
C. 3
D. 4
A. full mesh
B. peer-to-peer
C. partial mesh
D. hub and spoke
最新試題
Refer to the exhibit. Which two of these are characteristics of a firewall running in transparent mode？（）
Which path selection protocol is used by Fibre Channel fabrics？（）
The Cisco NAC Appliance is able to check which three items before allowing network access？（）
Which statement correctly describes a situation in which VRFs are used in the data center？（）
Which two statements correctly describe a situation in which an Active/Standby Service Module design is being used？ （）
Which two of these correctly describe Fibre Channel？（）
Which signal and noise values will result in the best phone communication with an access point？（）
Which three mechanisms are used to secure management traffic from outside IPS sensors？（）
Which three of the following descriptions are true about the firewall modes？ （）
Which two of these correctly describe asymmetric routing and firewalls？ （）