A.show ip ospf
B.show ip protocols
C.show ip ospf neighbor
D.show ip ospf interface
您可能感興趣的試卷
你可能感興趣的試題
You have a multi-area OSPF network and you’re concerned because one of the sites is havingconnectivity problem to resources in a different area. Which IOS privileged mode command wouldyou enter to confirm that your network：
（A） has a path to its ABR，
（B） has a path to its ASBR， and
（C）the SPF calculation is functional？（）
A.show ip protocols
B.show running-config
C.show ip ospf neighbor
D.show ip ospf border-routers
A.show ip ospf
B.show ip route
C.show ip protocol
D.show ip ospf database
E.None of the other alternatives apply
A.Each router has an identical link state database
B.External routes are imported into a separate link state database
C.Synchronization of link state databases is maintained via flooding of LSAs
D.Information in the link state database is used to build a routing table by calculating a shortest-path tree
E.By default， link state databases are refreshed every 10 minutes in the absence of topologychanges
DR （Designated Router） is for environments where many routers on the same network such asEthernet. In the following presented network， all routers are reloaded simultaneously， and DR isselected as expected. What is the CK-RTC status？（）
A.2WAY/BDR
B.FULL/BDR
C.2WAY/DROTHER
D.2WAY/DR
E.FULL/DROTHER
F.FULL/DR
G.None of the other alternatives apply
A.Spanning Tree Protocol（STP）
B.Delay reduction
C.Hot Standby Routing Protocol（HSRP）
D.Dynamic routing protocols
E.Quality of Service（QoS）
F.Jitter management
最新試題
Which statement correctly describes IPsec VPN backup technology？（）
Drag and drop the steps in the process for provisioning a cable modem to connect to a headendon the above to the below in the order defined by the DOCSIS standard.
Drag and drop question. The upper gives the MPLS functions， the bottom describes the planes.Drag the above items to the proper location at the below
Drag the DSL local loop topic on the left to the correct descriptions on the right.
Drag the protocols that are used to distribute MPLS labels from the above to the target area on thebelow.（Not all options will be used）
You need to configure a GRE tunnel on a IPSec router. When you are using the SDM to configurea GRE tunnel over IPsec， which two parameters are required when defining the tunnel interfaceinformation？（）
IPSec VPN is a widely-acknowledged solution for enterprise network. What are the four steps tosetup an IPsec VPN？（）
Drag the IOS commands from the left that would be used to implement a GRE tunnel using the10.1.1.0.30 network on interface serial 0/0 to the correct target area on the right.
Drag the DSL technologies on the left to their maximum（down/up） data rate values on the below.
Which statement about PPPoA configuration is correct？（）