A.association request/response, probe request/response, authentication request/response
B.association request/response, authentication request/response, probe request/response
C.probe request/response, authentication request/response, association request/response
D.probe request/response, association request/response, authentication request/response
E.None of the other alternatives apply
您可能感興趣的試卷
你可能感興趣的試題
Exhibit:
In this scenario the signal transmitted from the AP is reflected off a wall, resulting in multipathinterference at the client end (ClientA). Which of the following statements is true?()
A.The transmitted signal from the AP arrives at the client at slightly different times resulting inphase shifting
B.Multipath interference can be solved by using dual antennas
C.If signal 2 is close to 360 degrees out of phase with signal 1, the result is essentially zero signalor a dead spot in the WLAN
D.Multipath interference is less of an issue when using a DSSS technology because multipath isfrequency selective
E.If signal 1 is in phase with signal 2, the result is essentially zero signal or a dead spot in theWLAN
F.None of the other alternatives apply
Exhibit:
You work as a network technician. Please study the exhibit carefully. In this wireless network, theLAP (lightweight access point) attempts to register to a WLC (Wireless LAN Controller). What kindof message is transmitted?()
A.The lightweight access point will send Layer 2 and Layer 3 Lightweight Access Point (LWAPP)mode discovery request messages at the same time
B.The lightweight access point will send Layer 3 Lightweight Access Point (LWAPP) modediscovery request messages only
C.The lightweight access point will send Layer 2 Lightweight Access Point (LWAPP) mode discovery request messages. If the attempt fails, the LAP will try Layer 3 LWAPP WLC discovery
D.The lightweight access point will send Layer 2 Lightweight Access Point (LWAPP) modediscovery request messages only
A.Switchover ensures that Layer 2 through Layer 4 traffic is not interrupted
B.Redundancy requires BGP, OSPF, EIGRP, or IS-IS
C.Redundancy provides fast supervisor switchover for all Cisco Catalyst 6500 series switches
D.Switchover can be caused by clock synchronization failure between supervisors
A.independent of SSO
B.NSF combined with SSO enables supervisor engine load balancing
C.supported by RIPv2, OSPF, IS-IS, and EIGRP
D.supports IPv4 and IPv6 multicast
E.prevents route flapping
F.dependent on FIB tables
A.Static IP routes are maintained across a switchover because they are configured from entries inthe configuration file
B.Information about dynamic routing states, maintained on the active supervisor engine, issynchronized to the redundant supervisor engine and is transferred during the switchover
C.Information about dynamic routing states, maintained on the active supervisor engine, is notsynchronized to the redundant supervisor engine and is lost on switchover
D.The Forwarding Information Base (FIB) tables are cleared on a switchover. As a result, routedtraffic is interrupted until route tables reconverge
E.Static IP routes are cleared across a switchover and recreated from entries in the configurationfile on the redundant supervisor engine
F.The Forwarding Information Base (FIB) tables are maintained during the switchover. As aresult, routed traffic continues without any interruption when the failover occurs
最新試題
As a network engineer, study the exhibit carefully. Router Net is unable to establish an ADSLconnection with its provider. Which action would correct this problem?()
As a network engineer, do you know for what purpose SDM uses Security Device Event Exchange(SDEE)?()
Drag the DSL local loop topic on the left to the correct descriptions on the right.
This item contains several questions that you must answer. You can view these questions byclicking on the Questions button to the left. Changing questions can be accomplished by clicking the numbers to the left of each question. In order to complete the questions, you will need to referto the SDM and the topology, neither of which is currently visible.To gain access to either the topology or the SDK click on the button to left side of the screen thatcorresponds to the section you wish to access. When you have finished viewing the topology theSDK you can return to your questions by clicking on the Questions button to the left.Which defined peer IP address an local subnet belong to Crete?()
Drag and drop the xDSL type on the above to the appropriate xDSL description on the below.
Drag the IPsec protocol description from the above to the correct protocol type on the below.(Notall descriptions will be used)Drag and Drop question, drag each item to its proper location.
You need to configure a GRE tunnel on a IPSec router. When you are using the SDM to configurea GRE tunnel over IPsec, which two parameters are required when defining the tunnel interfaceinformation?()
Which three statements accurately describe IOS Firewall configurations?()
In computer security, AAA stands for authentication, authorization and accounting. Which optionabout the AAA authentication enable default group radius enable command is correct?()
Drag and drop question. The upper gives the MPLS functions, the bottom describes the planes.Drag the above items to the proper location at the below