A new switch is being installed and you have been assigned the task of connecting it to an existing switch. In doing this, you want to set up the VLAN Trunking Protocol so that VLAN information can be passed between the switches.
Which of the following must you do to accomplish this?（）
A. You must set each end of the trunk line to IEEE 802.1e encapsulation.
B. You must set the same VTP management domain name on both switches.
C. You must set all ports on the two switches as access ports.
D. You must configure one of the switches as a VTP server.
E. You must use a rollover cable to connect the two switches.
您可能感興趣的試卷
你可能感興趣的試題
You are bringing up a new Cisco Catalyst switch, and wish to connect it via a trunk to another switch from a different vendor, which uses the IEEE standard for the trunking method.
When setting the encapsulation type on the trunk, what should you configure on the Cisco switch?（）
A. Switch(config)# switchport trunk encapsulation isl
B. Switch(config)# switchport trunk encapsulation ietf
C. Switch(config-if)# switchport trunk encapsulation isl
D. Switch(config-if)# switchport trunk encapsulation ietf
E. Switch(config-if)# switchport trunk encapsulation dot1q
A. Create the VLAN.
B. Name the VLAN.
C. Configure an IP address for the VLAN.
D. Add the desired ports to the new VLAN.
E. Add the VLAN to the VTP domain.
A. TestKingD# disconnect 3
B. TestKingD# exit session 2
C. TestKingD# kill connection 1
D. TestKingD# show sessions
E. TestKingD# show connection all
F. TestKingD# resume 4
You wish to limit telnet access into your Cisco router to only a single host. In order to accomplish this, access list 1 has been written to allow host 172.16.1.224 access to the router vty lines.
What command would assign this access- list to the Virtual Terminal Lines?（）
A. router(config-line)# ip access-group 1 in
B. router(config-line)# access-class 1 in
C. router(config-line)# ip access-list 1 in
D. router(config-line)# access-line 1 in
A. Administratively shut down the interface.
B. Physically secure the interface.
C. Create an access list and apply it to the virtual terminal interfaces with the access-group command.
D. Configure a virtual terminal password and login process.
E. Enter an access list and apply it to the virtual terminal interfaces using the access-class command.
最新試題
Which statement describes the rule of split horizon?（）
Given a subnet mask of 255.255.255.224, which of the following addresses can be assigned to network hosts?（）
What is a global command?（）
An administrator would like to configure a switch over a virtual terminal connection from locations outside of the local LAN. Which of the following are required in order for the switch to be configured from a remote location? （）
Five minutes after issuing the show running-config command, a technician enters the command again and notices that several access list statements have been altered. Because of this, the technician believes that the router is being configured by an unknown person through Telnet. Before changing the router passwords, the technician would like to discover if anyone is connected to the router by Telnet and stop them from making further changes.Which commands will accomplish these options?（）
What is the subnetwork address for a host with IP address 201.100.5.68/28?（）
Which command is used to display the placement and direction of an IP access control list on a router?（）
What feature of a networks switch allows an administrative to create separate broadcast domains?（）
Which of the following options lists the steps in PPP session establishment in the correct order?（）
Which Frame Relay feature is responsible for transmitting keepalives to ensure that the PVC does not shut down because of inactivity?（）