A.Cable modems only operate at Layer 1 of the OSI model.
B.Cable modems operate at Layers 1 and 2 of the OSI model.
C.Cable modems operate at Layers 1, 2, and 3 of the OSI model.
D.A function of the cable modem termination system (CMTS) is to convert the modulated signal from the cable modem into a digital signal.
E.A function of the cable modem termination system is to convert the digital data stream from the end user host into a modulated RF signal for transmission onto the cable system.
您可能感興趣的試卷
你可能感興趣的試題
A.Dead Peer Detection (DPD)
B.CDP
C.isakmp keepalives
D.GRE keepalive mechanism
E.The hello mechanism of the routing protocol across the IPsec tunnel
Refer to the exhibit. Which statement is true about the partial MPLS configuration that is shown?()
A.The route-target both 100:2 command sets import and export route-targets for vrf2.
B.The route-target both 100:2 command changes a VPNv4 route to a IPv4 route.
C.The route-target import 100:1 command sets import route-targets routes specified by the route map.
D.The route-target import 100:1 command sets import route-targets for vrf2 that override the other route-target configuration.
Refer to the exhibit. Which statement is true about the configuration of split tunnels using SDM?()
A.Any protected subnets that are entered represent subnets at the end user’s site that will be accessed without going through the encrypted tunnel.
B.Any protected subnets that are entered represent subnets at the end user’s site that will be accessed through the encrypted tunnel.
C.Any protected subnets that are entered represent subnets at the VPN server site that will be accessed without going through the encrypted tunnel.
D.Any protected subnets that are entered represent subnets at the VPN server site that will be accessedthrough the encrypted tunnel.
A.All passwords entered during the AutoSecure configuration must be a minimum of 8 characters in length.
B.Cisco123 would be a valid password for both the enable password and the enable secret commands.
C.The auto secure command can be used to secure the router login as well as the NTP and SSH protocols.
D.For an interactive full session of AutoSecure, the auto secure login command should be used.
E.If the SSH server was configured, the 1024 bit RSA keys are generated after the auto secure commandis enabled.
Refer to the exhibit.
What does the "26" in the first two hop outputs indicate?()
A.the outer label used to determine the next hop
B.the IPv4 label for the destination network
C.the IPv4 label for the forwarding router
D.the IPv4 label for the destination router
最新試題
What are two possible actions an IOS IPS can take if a packet in a session matches a signature?()
Refer to the exhibit. MPLS has been configured on all routers in the domain. In order for R2 and R3 to forward frames between them with label headers, what additional configuration will be required on devices that are attached to the LAN segment?()
Which two statements about the Cisco AutoSecure feature are true?()
Refer to the exhibit. Which statement is true about the configuration of split tunnels using SDM?()
Which three techniques should be used to secure management protocols?()
Which statement about an IPS is true?()
When configuring the Cisco VPN Client,what action is required prior to installing Mutual Group Authentication?()
Which two statements about an IDS are true?()
Which statement is true when ICMP echo and echo-reply are disabled on edge devices?()
Refer to the exhibit.Which three statements describe the steps that are required to configure an IPsec site-to-site VPN using a GRE tunnel?()