Cat6500（config）# router ospf 1
Cat6500（config-router）# network 0.0.0.0 255.255.255.255 area 0
Cat6500（config-router）# nsf Cat6500（config-router）#end
Refer to the exhibit. The configuration is used to enable nonstop forwarding for OSPF on a Catalyst 6500 Series
Switch with redundant supervisor engines.
The default CEF configuration is unchanged. After testing， user traffic is interrupted and NSF is not operational.
What is the most likely reason？ （）
A.CEF was not properly configured.
B.OSPF was not properly configured for graceful restart.
C.Stateful switchover was not correctly configured.
D.NSF for OSPF is only supported in area 0.
您可能感興趣的試卷
你可能感興趣的試題
To initiate testing，
which port does a Cisco IOS IP SLA source use to send a control message to an IP SLA responder？ （）
A.UDP port 2020
B.UDP port 1967
C.TCP port 2020
D.ICMP port 1967
A.required at the destination to implement Cisco IOS IP SLA services
B.improves measurement accuracy
C.required for VoIP jitter measurements
D.provides security on Cisco IOS IP SLA messages via LEAP or EAP-FAST authentication
E.responds to one Cisco IOS IP SLA operation per port
F.stores the resulting test statistics
A.only implemented between Cisco source and destination-capable devices
B.statistics provided by syslog， CLI， and SNMP
C.measures delay， jitter， packet loss， and voice quality
D.only monitors VoIP traffic flows
E.provides active monitoring
F.provides passive monitoring
A.Test major changes before deployment and defer minor changes until during deployment.
B.Document and verify rollback procedures.
C.Ensure consistency of code versions across the network.
D.Progressively modify procedures and documentation during implementation.
A.work staff attributes， such as skills and communication
B.redundancy， to prevent single points of failure
C.processes， such as documentation， change control， and labs
D.appropriate technology， such as hardware and software
E.tools， such as those for monitoring and reporting
最新試題
Refer to the exhibit. Switch 15 is configured as the root switch for VLAN 10 but not for VLAN 20. If the STP configuration is correct， what will be true about Switch 15？（）
What is the configured priority value of the Vlan105’s group on DS2 ？（）
Refer to the exhibit. The command switchport mode access is issued on interface FastEthernet0/13 on switch CAT1. What will be the result？（）
Based on the show spanning-tree vlan 200 output shown in the exhibit， which two statements about the STP process for VLAN 200 are true？ （）
Which two statements are true when the extended system ID feature is enabled？ （）
Refer to the exhibit. Which Virtual Router Redundancy Protocol （VRRP） statement is true about the roles of the master virtual router and the backup virtual router？（）
Refer to the exhibit. Initially， LinkA is connected and forwarding traffic. A new LinkB is then attached between SwitchA and HubA. Which two statements are true about the possible result of attaching the second link？（）
Refer to the exhibit. For what purpose is the command show ip cef used？（）
What must be the same to make multiple switches part of the same Multiple Spanning Tree （MST）？（）
During routine maintenance， it became necessary to shutdown G1/0/1 on DS1 and DS2. All other interface were up. During this time， DS1 became the active device for Vlan104’s HSRP group. As related to Vlan104’s HSRP group. What can be done to make the group function properly ？ （）