A.CEF, distributed CEF (dCEF), fast switching, process switching
B.distributed CEF (dCEF), CEF, fast switching, process switching
C.fast switching, process switching, distributed CEF (dCEF), CEF
D.process switching, fast switching, distributed CEF (dCEF), CEF
E.process switching, distributed CEF (dCEF), CEF, fast switching
F.process switching, CEF, distributed CEF (dCEF), fast switching
您可能感興趣的試卷
你可能感興趣的試題
A.LACP is used to connect to non-Cisco devices.
B.LACP packets are sent with the command channel-group 1 mode desirable.
C.LACP packets are sent with the command channel-group 1 mode active.
D.Standby interfaces should be configured with a higher priority.
E.Standby interfaces should be configured with a lower priority.
Refer to the exhibit. All network links are FastEthernet. Although there is complete connectivity throughout the network, Front Line users have been complaining that they experience slower network performance when accessing the server farm than the Reception office experiences. Based on the exhibit,
which two statements are true?()
A.Changing the bridge priority of S1 to 4096 would improve network performance.
B.Changing the bridge priority of S1 to 36864 would improve network performance.
C.Changing the bridge priority of S2 to 36864 would improve network performance.
D.Changing the bridge priority of S3 to 4096 would improve network performance.
E.Disabling the Spanning Tree Protocol would improve network performance.
F.Upgrading the link between S2 and S3 to Gigabit Ethernet would improve performance.
A.The BID is made up of the bridge priority value(two bytes) and bridge MAC address (six bytes).
B.The BID is made up of the bridge priority (four bits), the system ID (12 bits), and a bridge MAC address (48 bits).
C.The BID is made up of the system ID (six bytes) and bridge priority value (two bytes).
D.The system ID value is the VLAN ID (VID).
E.The system ID value is a unique MAC address allocated from a pool of MAC addresses assigned to the switch or module.
F.The system ID value is a hex number used to measure the preference of a bridge in the spanning-tree algorithm.
Based on the show spanning-tree vlan 200 output shown in the exhibit,
which two statements about the STP process for VLAN 200 are true? ()
A.BPDUs will be sent out every two seconds.
B.The time spent in the listening state will be 30 seconds.
C.The time spent in the learning state will be 15 seconds.
D.The maximum length of time that the BPDU information will be saved is 30 seconds.
E.This switch is the root bridge for VLAN 200.
F.BPDUs will be sent out every 10 seconds.
A.HSRP
B.GLBP
C.VRRP
D.SLB
E.RPR
F.RPR+
最新試題
Which statement is correct about the use of the virtual interface on a WLC ?()
Refer to the exhibit. The command switchport mode access is issued on interface FastEthernet0/13 on switch CAT1. What will be the result?()
Which two statements are true when the extended system ID feature is enabled? ()
Based on the show spanning-tree vlan 200 output shown in the exhibit, which two statements about the STP process for VLAN 200 are true? ()
During routine maintenance, G1/0/1 on DS1 was shutdown. All other interface were up. DS2 became the active HSRP device for Vlan101 as desired. However, after G1/0/1 on DS1 was reactivated. DS1 did not become the active HSRP device as desired. What need to be done to make the group for Vlan101 function properly ? ()
DS2 has not become the active device for Vlan103’s HSRP group even though all interfaces are active. As related to Vlan103’s HSRP group. What can be done to make the group function properly ? ()
Which router redundancy protocol cannot be configured for interface tracking?()
Which three statements are true of the Link Aggregation Control Protocol (LACP)?()
Refer to the exhibit. Which statement is true about the output?()
Refer to the exhibit. Initially, LinkA is connected and forwarding traffic. A new LinkB is then attached between SwitchA and HubA. Which two statements are true about the possible result of attaching the second link?()