The following output occurs on Router R1. IP SLA operation 1 uses an ICMP echo operation type, with default frequency of 60 seconds. The operation pings from address 1.1.1.1 to address 2.2.2.2. Which of the following answers is true reg arding IP SLA and object tracking on R1?（）
R1# show track
Track 2
IP SLA 1 state
State is Up
3 changes, last change 00:00:03
Delay up 45 secs, down 55 secs
Latest operation return code: OK
Latest RTT (millisecs) 6
Tracked by:
STATIC - IP - ROUTING 0
A. The tracking return code fails after the SLA operation results in an ICMP echo failure three times.
B. The tracking return code fails after the SLA operation results in an ICMP echo failure one time.
C. After the tracking object fails, the tracking o bject moves back to an up state 45 seconds later in all cases.
D. After moving to a down state, the tracking object moves back to an OK state 45 seconds after the SLA operation moves to an OK state.
您可能感興趣的試卷
你可能感興趣的試題
The following configuration commands exist only in an implementation plan document. An engineer does a copy/paste of these commands into configuration mode on Router R1. Which of the following answers is m ost accurate regarding the results?（）
ip sla
1
icmp - echo 1.1.1.1 source -ip 2.2.2.2
ip sla schedule 1 start - time now life forever
A. The SLA operation will be configured but will not start until additional commands are used
B. The SLA operation is not comp letely configured so it will not collect any datA
C. The SLA operation is complete and working, collecting data into the RTTMON MIB
D. The SLA operation is complete and working but will not store the data in the RTTMON MIB without more configuration
A. ICMP Echo
B. VoIP (RTP)
C. IPX
D. SNMP
The following output occurs on Router R2. Which of the following statements can be confirmed as true based on the output from R2?（）
R2# show ip policy
Interface Route map
Fa0/0 RM1
Fa0/1 RM2
S0/0/0 RM3
A. R2 will forward all packets that enter Fa0/0 per the PBR configuration.
B. R2 will use route map RM2 when determining how to forward packets that exit interface Fa0/1.
C. R2 will consider using PBR for all packets exiting S0/0 /0 per route map RM3.
D. R2 will consider using PBR for all packets entering S0/0/0 per route map RM3.
Examine the following configuration on Router R1. R1's show ip route 172.16.4.1 command list s a route with outgoing interface S0/1/1. Host 172.16.3.3 uses telnet to connect to host 172.16.4.1.What will Router R1 do with the packets generated by host 172.16.3.3 because of the telnet,assuming the packets enter R1's F0/0 interface?（）
interface Fastethernet 0/0
ip address 172.16.1.1 255.255.255.0
ip policy route - map Q2
!
route - map Q2 permit
match ip address 101
set interface s0/0/1
!
access - list 101 permit tcp host 172.16.3.3 172.16.4.0 0.0.0.255
A. The packet will be forwarded out S0/0 /1, or not at all.
B. The packet will be forwarded out S0/0/1 if it is up.
C. The packet will be forwarded out S0/1/1 if it is up.
D. The packet will be forwarded out S0/1/1 if it is up, or if it is not up, out s0/0/1.
E. The packet will be forwarded o ut S0/0/1 if it is up, or if it is not up, out s0/1/1.
A. Packets entering F0/0 will be compared based on the PBR route map.
B. Packets exiting F0/0 will be compared based on the PBR route map.
C. IOS ignores the PBR forwarding directions wh en the packet matches a route map deny clause.
D. IOS ignores the PBR forwarding directions when the packet matches a route map permit clause.
最新試題
Which of the following is helpful to allow an IPv6 host to learn the IP address of a default gateway on its subnet?（）
The following line of output was gathered on Enterprise Router Ent1 using the command show ip route. Which of the following answers is most likely to be true, based on thi s output？（）B 128.107.0.0 [20/10] via 11.11.11.11, 00:02:18
Router R1 currently has no configuration related to IPv6 or IPv4. The following configuration exists in a planning document, intended to be used to copy/paste into Router R1 to enable OSPFv3 on interfaces F0/0 and S0/0/0. No other related configuration exists. Assuming F0/0 and S0/0/0 reach an up/up state, which of the following is true about OSPFv3 on R1 after this configuration has been pasted into R1?（）ipv6 router ospf 1ipv6 unicast- routinginterface f0/0ipv6 address 2000 ::1/64ipv6 ospf 1 area 1interface s0/0/0ipv6 address 2001::/64 eui - 64ipv6 ospf 1 area 0
Which of the following features work the same in both RIP- 2 and RIPng?（）
The following configuration exists on a router on one end of an IPv6 tunnel. Although the configuration added so far is correct, the configuration is incomplete. Which type of tunnel is most likely to be intended by the network engineer？（）interface loopback 1ip address 192.168.1.1 255.255.255.255interface tunnel 2ipv6 address 2002:C0A8:10 1::1/64tunnel source loopback 1
Which of the following are true of both OSPFv2 and OSPFv3?（）
Router R1 has the following configuration. Assuming R1's F0/0 interface has a MAC address of 0200.0011.1111, what IPv6 addresses will R1 list for interface F0/0 in the output of the show ipv6 interface brief command?（）interface f0/0ipv6 address 2345:0:0:8::1/64
The answers each list a tunnel method and two consecutive IPv6 address quartets.Which answers identify a tunneling method that relies on an IPv4 address to be embedded into an IPv6 address, within the correct quartets listed?（）
An enterprise h as plans to start adding IPv6 support. For the first year, the IPv6 will be in small pockets spread around the existing large IPv4 network, with occasional IPv6 traffic while applications teams test IPv6 - enabled servers and applications.Which of the fol lowing tools would be most appropriate?（）
An engineer is reviewing another engineer's sample configuration for a GRE tunnel used to pass IPv6 traffiC. The tunnel ha s not yet been configured on the router.Which of the following commands is not required for the configuration to pass IPv6 traffic?（）