Scalability： with the cisco wireless location appliance， 2500 devices including wireless clients or wi-fi tags can be tracked simultaneously， helping ensure that location services can be applied to an entire enterprise environment.
Which of the following functions on the wireless lan controller is used to determine whether or not a rogue access point is connected to the same layer 2 network？（）
A.rogue detector
B.rogue containment
C.rldp
D.ridp
您可能感興趣的試卷
你可能感興趣的試題
A.1000
B.2000
C.2500
D.1500
You are troubleshooting a problem with a cisco 7920 wireless ip phone on a standalone wlan. the phone rings but， when you Answer ，the call is dropped.
What may have caused this problem？（）
A.publicly secure packet forwarding is enabled.
B.the minimum data rate is not set to 11 mbps.
C.an address resolution protocol is enabled.
D.the access point is set to the least congested channel.
A cisco wcs version 4.0 has been installed on a server with a dual pentium 3.0 ghz processor，4 gb ram，and an 80 gb hard drive. a location appliance has been incorporated into the network and is being monitored by the cisco wcs. there are 3000 devices to be tracked but not all of them are being tracked on the cisco wcs.
What can be done to correct the problem？（）
A.add a new location appliance.
B.add a new cisco wcs server dedicated to the location appliance.
C.add 4 gb of ram to the cisco wcs.
D.add a 120 gb hard drive to the cisco wcs.
You are troubleshooting a problem with a cisco 7920 wireless ip phone that is causing the phone to drop calls. the problem appears to be a roaming bandwidth issuE. in order to verify what kind of issue it is， you decide to increase the bandwidth reserved for roaming on the wlan controller to the maximum.
What level do you set the bandwidth to？（）
A.25 percent
B.15 percent
C.5 percent
D.35 percent
Using the wlse， you are trying to push out a configuration job to a standalone access point， but the job does not start.
Which of the following would cause this failure？（）
A.invalid parameter in the template
B.incorrect snmp communities on the access point
C.pop-up blocker enabled in the browser
D.unsupported version of ios firmware in the access point
最新試題
You are troubleshooting a problem with a Cisco 7920 wireless IP phone that is causing the phoneto drop calls. The problem appears to be roaming bandwidth issue. In order to verify what kind ofissue it is， you decide to increase the bandwidth reserve for roaming on the WLAN controller tomaximum.What level do you set the bandwidth to？（）
When configuring a WLAN controller for a voice application using Cisco 7920 wireless IP phones，which two general control settings should you select？（）
The IOS of a North American Cisco Aironet 1130AG Series standalone access point has becomecorrupt. You must therefore reload the TFTP firmware.Before you press and hold the MODEbutton， you should verify that the file name is which of the following？（）
You want to dynamically assign users to an 802.1Q VLAN as a result of their authentication. Inorder to accomplish this.Which two IETF RADIUS attributes should you configure on the CiscoSecure ACS？ （）
You are installing a Cisco 4402 Series Wireless LAN Controller.What type of interface is used on the uplink port？（）
You are configuring a wireless LAN controller for QoS.Which 802.11e user priority tag should you apply to voice applications？（）
What is the maximum number of wireless controllers that the highest-end Cisco WCS server canmanage？（）
Which of the following accurately represents the functionality of a lightweight access point configured to operate in sniffer AP mode？（）
An REAP was supporting 16 WLANs， but now it only supports one.What happened to cause the change？（）
You are trying to change the polling parameters used by the location manager via the Cisco WCS，and your request is being denied. What is wrong？（）