A.TIFF
B.DXF
C.PNG
D.DWG
您可能感興趣的試卷
你可能感興趣的試題
A.per SSID
B.per access point
C.globally
D.per WLAN and radio
A.Fresnel units
B.decibels
C.EIRP
D.milliamperes
E.ohms
A.rogue access point detection in the coverage area
B.multipath issues in the coverage area
C.number of VoWLAN users in the coverage cell
D.call capacity requirements of the coverage area
A.green
B.blue
C.yellow
D.red
E.purple
F.white
A.SNR
B.noise floor
C.level of interference
D.Received Signal Strength Indicator
最新試題
When surveying for VoWLAN, which power level should you base the access point coverage designon?()
Cisco recommends a decibel referenced to 1 milliwatt signal level for the coverage cell edge at thepredetermined data rate that is needed to support the VoWLAN device and call capacityrequirements. What is that signal level value for Cisco Unified Wireless IP Phones 7920, 7921G, and7925G?()
When conducting a wireless voice site survey, which two sizing considerations exist for thecoverage cell?()
The Cisco Aironet 1140 Series Access Point draws 12.95 W at the power source. However, whenusing a long Ethernet cable, the device can draw up to how much additional wattage?()
How should the transmit power on an access point and client each be set during a site survey?()
Which two Cisco antennas provide better isolation from RF sources that might be located behindthe antennas?()
According to the following statement, can you tell me which term is described?()It is the air return for an air conditioned system. In most buildings, the area above a drop ceiling orunder a raised floor is used as the air return (source of air) for the air conditioning. Those dropceiling and raised floors are also where wire is often installed. If wire and cable is installed in a dropceiling or raised floor, it is out of sight. If that cable were burning, it would give off toxic fumes.These would be fed to the rest of the building by the air conditioner. As a result, people could beinjured even though they are a long way from the fire.
Which can NOT be selected for supported services in Cisco WCS Planning Tool?()
What is the minimum recommended access point overlap for voice roaming?()
In an outdoor bridge link, what is calculated by using this formula: transmitter power + antennagain - insertion OR cable loss()?