lightweight access point has been connected to a catalyst 3550 24-pwr switch， and on power-up the access point fails.
What is the problem with the switch？（）
A.the power supply has inadequate wattage.
B.power is incorrectly configured on the port.
C.it does not support 802.3af poe.
D.power is not enabled on the port.
您可能感興趣的試卷
你可能感興趣的試題
Two access points running the core feature set are connected to the same switch and are
providing guest services. if pspf is enabled.
What must be enabled on the switch to prevent clients from seeing one another’s data？（）
A.port-based radius
B.802.1q trunking
C.inline power
D.protected port
A.startup
B.site survey mode
C.lost connection to the controller
D.duplicate ip address
Last december you erected a bridge link between two buildings on your campus. it is now april and the foliage in the trees is full， and the bridge link will no longer maintain connectivity.
Which action will most likely solve the problem？（）
A.change the channel selection.
B.install higher gain antennas.
C.raise the antennas.
D.increase transmitter power.
An 802.1x client cannot authenticate to an autonomous access point configured for multiple vlans. the native vlan does not have an ssid configured.
Which one of the following links being down would prevent the clients from authenticating？（）
A.between the radius and the access point
B.between the client’s vlan and the wlse
C.between the native vlan and the wlse
D.between the client’s vlan and the radius
A.1
B.4
C.2
D.5
E.3
最新試題
You are configuring an RF group of controllers that coordinate Radio Resource Management calculations.What is the maximum number of WLAN controllers that you can add？（）
You are troubleshooting a one-way call problem with a Cisco 7920 wireless IP phone on a standalone WLAN.What may cause this problem？（）
What is the maximum number of wireless controllers that the highest-end Cisco WCS server canmanage？（）
You are installing a Cisco 4402 Series Wireless LAN Controller.What type of interface is used on the uplink port？（）
On a Cisco Aironet 1240AG Series standalone access point， the radio LED is dark blue and blinking，but the status LED and Ethernet LED are both off.What does this indicate？（）
Clients using Cisco-LEAP and EAP-FAST authentication are having no problems logging on to thewireless network， but clients using PEAP are failing to log on.Which situation would result in thistype of problem？（）
Static WEP is configured on the access point. You are authenticated and associated to the accesspoint but are unable to obtain an IP address.Which of the following will cause this problem？（）
Which protocol does the RADIUS server use inside the secure tunnel of EAP-FAST to authenticatethe client when one-time passwords are in use？（）
A Cisco WCS version 4.0 has been installed on a server with a dual Pentium 3.0 GHz processor，4GB RAM， and an 80 GB hard drive. A location appliance has been incorporated into the networkand is being monitored by the Cisco WCS. There are 3000 devices to be tracked but not all of themare being tracked on the Cisco WCS.What can be done to correct the problem？（）
You have been called upon to add location-based services into an existing controller-basedwireless design which primarily encompasses handheld devices such as barcode scanners and Cisco7920 wireless IP phones.In which mode should you deploy the additional access points to achievethe density required without excessive co-channel interference？（）