多項選擇題

You are an experienced network administrator in an international company. During your working hours, customers complain that they experience intermittent data loss and they intermittently fail to connect to crucial servers. As shown in the following topology, the 802.1Q trunk between DSW111 and ASW1 fails. Though DSW112 is in the service of HSRP group 11, the SVI for VLAN 11 is up on DSW111.
So as to figure out the problem,
which three commands should you issue on DSW111? ()(Choose three.)

A. show standby vlan 11 brief
B. show interfaces vlan 11
C. show spanning-tree vlan 11
D. show interfaces mod/port trunk


您可能感興趣的試卷

你可能感興趣的試題

1.單項選擇題

You are troubleshooting an issue which is causing full-sized packets entering the MPLS cloud be dropped. You have discovered that one of the switches in the MPLS core is not a Cisco switch, but otherwise the MPLS MTU size is set to 1508 bytes on the routers.
Based on this information, which of these may be the reason the packets are being dropped?()

A. The switch on you MPLS core that was not produced by Cisco does not support oversized packets
B. No switches support oversized packets
C. By definition, the maximum MTU is 1500 bytes
D. As MPLS VPN labeling increases the size of the packet by 8 bytes, the IP MTU should have been changed to 1508

3.單項選擇題On a Cisco Catalyst 4500 Series, the fail LED is lit for one if its two power supplies. Which command would you use to check on this problem ?()

A. Show module
B. Show errdisable detect
C. Show environment
D. Show diagnostic content

5.單項選擇題

As an experienced Network Engineer, you are required to implement the security architecture assessment.
Which of the following statement describes the most important reason for that?()

A. Create a design specification document.
B. Integrate routing and switching components.
C. Document power and UPS availability
D. Document the customer's current and future technology projects.

最新試題

You are an experienced network administrator in an international corporation. During your working hours, you are asked to deploy the Cisco SSL VPN AIM module in a Cisco 1800 Series Router. The beneficial reason for that deployment is to:()

題型:單項選擇題

Which keyword is used with the show ip bgp neighbors [keyword] command to display all routes that are received and accepted from a neighbor?()

題型:單項選擇題

Refer to the exhibit. Analyze the two traceroutes that are displayed. Which of these statements is correct in describing what most likely caused the traceroute differences?()

題型:單項選擇題

Which keyword is used with the debug ipv6 [keyword] command to troubleshoot neighbor discovery problems?()

題型:單項選擇題

Refer to the exhibit. For the given configuration, on packets leaving the router on interface FastEthernet0/0 that matches the high traffic class, what will the MPLS experimental bit be set to?()

題型:單項選擇題

When a Cisco router is configured for SSH, it acts as an ()?

題型:單項選擇題

With a VPN Accelerator Module 2+ (VAM2+) installed in a Cisco 7200 series router, what will be the resulting action when entering the command no crypto engine accelerator slot number?()

題型:單項選擇題

Which of the following is an easy-to-use tool that allows you to easily configure and monitor Cisco Integrated Services Routers?()

題型:單項選擇題

Which configuration will enable OSPF for IPv6 on FastEthernet 0/0/0?()

題型:單項選擇題

In a high-availability network, which command, when placed on ports that have connected end stations, will allow you to prevent delays in service for end stations by placing a port in blocking mode?()

題型:單項選擇題