A. to configure a subinterface so that it can be applied to the primary interface in order to prevent exponential selective dampening
B. to suppress the effects of excessive interface flapping events on routing protocols and routing tables in the network
C. to introduce a nonconfigurable exponential delay mechanism
D. to allow the network operator to configure a router to automatically dampen and selectively identify a local interface that is failing
您可能感興趣的試卷
你可能感興趣的試題
CIS .com recently acquired a smaller competitor. The acquired company is not currently using Cisco routers, so you have connected the two WANs via an authenticated PPP link. After configuration both routers, issuing the show interface s0/0 command on the Cisco Router shows the interface to be in the up/down state.
Which two of these are possible causes? （）
A. Bandwidth statements do not match
B. MTUs do not match
C. IP Addresses are not in the same subnet
D. CHAP passwords do not match
A. flags indicating the kind of autoconfiguration that can be done by hosts
B. default router information
C. /64 prefix that can be used on the link and the lifetime of the prefix
D. IPv6 DHCP server address information
A. isolated mode
B. modular mode
C. community mode
D. promiscuous mode
E. non-isolated
F. permanent
A.65536
B.256
C.1024
D.16777216
最新試題
Which three of these items are IPv6 transition mechanisms? （）(Choose three.)
Refer to the exhibit. Analyze the two traceroutes that are displayed. Which of these statements is correct in describing what most likely caused the traceroute differences?（）
What is the most likely reason that an IBGP route that has been selected as a best route is not entered into the IP routing table?（）
Refer to the exhibit. For the given configuration, on packets leaving the router on interface FastEthernet0/0 that matches the high traffic class, what will the MPLS experimental bit be set to?（）
You have just reinstalled a VIP 6-80 in a Cisco 7500 Series router. What must you do to bring up the port adapter interfaces?（）
Which command is used to view IPv6 parameters related to the BGP process?（）
As an experienced network engineer, you are asked to troubleshoot a CIS network outage. During the troubleshooting process, you notice that one of your colleagues connects additional devices to the network with the use of his own switch. With the purpose of improving speed, the switch is attached to both network ports in an office, which leads to bridge loop.Enabling which of the following feature will be able to prevent this problem from happening again?（）
You are trying to initiate an SSH connection to a remote router and are getting rejected with an error code of 0. Which of these might be the cause of the error?（）
With a VPN Accelerator Module 2+ (VAM2+) installed in a Cisco 7200 series router, what will be the resulting action when entering the command no crypto engine accelerator slot number?（）
What are four advantages to using tunnel brokers in an IPv6 transition environment?（）