When configuring a WLAN controller for a voice application using Cisco 7920 wireless IP phones.
Which two general control settings should you select？ （）
A.Aggressive Load Balancing on
B.Aggressive Load Balancing off
C.Multicast on
D.Multicast off
E.AP Fallback on
F.AP Fallback off
您可能感興趣的試卷
你可能感興趣的試題
Clients using Cisco-LEAP and EAP-FAST authentication are having no problems logging on to the wirelessnetwork， but clients using PEAP are failing to log on.
Which situation would result in this type of problem？（）
A.The AAA server is set to accept both MS-CHAP v2 and GTC for PEAP authentication.
B.Clients have been set to validate the server identity.
C.Posture validation has not been enabled.
D.Clients and server are not using certificates.
You review the Failed Attempts logs on an AAA server and find： "unknown network access server error."
Which failure could produce this error？（）
A.failure of the wireless client and AAA server handshake
B.supplicant authentication failureB.AAA client and AAA server handshake failure
C.wrong password used by the supplicant
On a Cisco Aironet 802.11 a/b/g wireless LAN client adapter， the status LED and activity LED arealternating on and off.
What does this indicate？（）
A.The client card has failed.
B.The client card is not associated to the network.
C.The driver has been installed incorrectly.
D.The client card has awakened from power-save mode.
A.4 to 6 times the tag beaconing rate
B.6 to 8 times the tag beaconing rate
C.8 to 10 times the tag beaconing rate
D.10 to 12 times the tab beaconing rate
On a Cisco Aironet 1240AG Series standalone access point， the radio LED is dark blue and blinking， butthe status LED and Ethernet LED are both off.
What does this indicate？（）
A.A firmware upgrade is in progress.
B.An access point buffer overflow is occurring.
C.The internal radio has failed.
D.The access point is booting.
最新試題
You are using ADU and are authenticated and associated to an access point. However， you are unable to obtain an IP address.Which of these has caused this problem？（）
You are troubleshooting a one-way call problem with a Cisco 7920 wireless IP phone on a standalone WLAN.What may cause this problem？（）
You have a very few Cisco 7920 wireless IP phones on your network， but lots of wireless laptops.You want to increase the bandwidth available for the laptops by decreasing the bandwidth reserved for the Cisco 7920 phones.What is the lowest percentage of voice-allocated bandwidthyou can select on the WLAN controller？（）
You are charges with implementing a secure wireless installation which will provide Internet accessto client devices but will not allow communications between wireless clients.In addition to implementing PSPF or peer-to-peer blocking on the wireless side，which of the following actionsshould you perform on the wired infrastructure？（）
Which protocol does the RADIUS server use inside the secure tunnel of EAP-FAST to authenticatethe client when one-time passwords are in use？（）
The Cisco Wireless Location Appliance provides an audit trail for each device tracked for up to how many days？（）
How many WLANs can a Cisco Aironet 1242 in H-REAP mode support when actively connected toa wireless controller？（）
The IOS of a North American Cisco Aironet 1130AG Series standalone access point has becomecorrupt. You must therefore reload the TFTP firmware.Before you press and hold the MODEbutton， you should verify that the file name is which of the following？（）
You are installing a Cisco 4402 Series Wireless LAN Controller.What type of interface is used on the uplink port？（）
You are troubleshooting a problem with a Cisco 7920 wireless IP phone on a standalone WLAN.The phone rings but， when you answer， the call is dropped.What may cause this problem？（）