A.Full-duplex Ethernet consists of a shared cable segment. Half-duplex Ethernet provides a point-to-point link.
B.Full-duplex Ethernet uses a loopback circuit to detect collisions. Half-duplex Ethernet uses a jam signal.
C.Full-duplex Ethernet can provide higher throughput than can half-duplex Ethernet of the same bandwidth.
D.Full-duplex Ethernet uses two wires to send and receive. Half-duplex Ethernet uses one wire to send and receive.
您可能感興趣的試卷
你可能感興趣的試題
A.copier
B.microwave oven
C.toaster
D.cordless phone
E.IP phone
F.AM radio
A.VTP
B.STP
C.ISL
D.802.1Q
E.VLSM
A.buffering
B.cut-through
C.windowing
D.congestion avoidance
E.load balancing
A.Layer 2
B.Layer 3
C.Layer 4
D.Layer 5
E.Layer 6
F.Layer 7
A.By default， all defined VLANs are allowed on the trunk.
B.Each single VLAN， or VLAN range， must be specified with the switchport mode command.
C.Each single VLAN， or VLAN range， must be specified with the vtp domain command.
D.Each single VLAN， or VLAN range， must be specified with the vlan database command.
最新試題
Which IPsec security protocol should be used when confidentiality is required?（）
A router receives information about network 192.168.10.0/24 from multiple sources.What will the router consider the most reliable information about the path to that network?（）
At which layer of the OSI model dose PPP perform?（）
While troubleshooting a network problem,a technician discovers that the current copy of the Cisco IOS is outdated and needs to be updated.Which of the following commands would the technician issue to replace the Cisco router IOS with the newer version?（）
The network administrator cannot to switch 1 over a telnet session,although the hosts attached to switch 1 can ping the interface Fa0/0 of the router.Given the information in the graphic and assuming that the router and switch2 are configured properly,which of the following commands should be issued on switch 1 to correct this problem?（）
What is the purpose of the cisco Vlan Trunking protocol?（）
On which options are standard access list based?（）
When you are troubleshooting an ACL issue on a router,which command can help you to verify which interfaces are affected by the ACL?（）
A network administrator needs to configure a serial link between the main office and a remote location.The router at the remote office is a non-cisco router. How should the network administrator configure the serial interface of the main office router to make the connection?（）
A network administrator is planning a network installation for a large organization.The design requires 100 separate subnetworks,so the company has acquired a Class B network address.What subnet mask will provide the 100 subnetworks required, if 500 usable host addresses are required per subnet?（）