單項選擇題You replaced your Layer 3 switch， which is the default gateway of the end users. Many users cannot access anything now， including email， Internet， and other applications， although other users do not have any issues. All of the applications are hosted in an outsourced data center. In order to fix the problem， which one of these actions should you take？（）

A.Clear the MAC address table in the switch.
B.Clear the ARP cache in the switch.
C.Clear the ARP cache in the end devices.
D.Clear the ARP cache in the application servers.


您可能感興趣的試卷

你可能感興趣的試題

2.多項選擇題The network administrator is trying to add Switch1 to the network， but the 802.1Q trunk is not coming up. Switch1 was previously tested in the laboratory and its trunk configuration worked fine. What are three possible causes of this problem？（）

A.The trunking configuration mode on Switch1 is set to Off.
B.The trunking configuration mode on the other end is set to On.
C.The trunking configuration mode on the other end is set to Desirable.
D.Cisco Discovery Protocol is not running on the other end.
E.There is a VTP domain name mismatch.
F.Switch1 does not support 802.1Q.

3.單項選擇題

Refer to the exhibit. When applying this policy map on the tunnel1 interface，you see packet loss for the TCP class starting at around 100000 b/s，instead of the configured 150000 b/s. What is the most likely？（）

A.The violate-action command should not be configured.
B.The current configuration of the load-interval command on the tunnel interface is preventing proper policing calculations.
C.The burst size is too low.
D.Policing on tunnel interfaces is not supported.
E.The CIR keyword is missing in the policer.

4.單項選擇題You have done a partial migration from 802.1D STP to 802.1w STP. Which of the following is true？（）

A.802.1D and 802.1w interoperate only when the 802.1D STP domain supports rapid convergence.
B.Ports leading to 802.1D devices will run in compatibility mode， while the rest of the ports will run in 802.1w mode.
C.This is an invalid configuration and a partial migration cannot be done.
D.The bridge timers will be set to match the 802.1D devices.
E.A secondary root bridge will always be populated within the 802.1D domain.
F.If the root bridge is selected within the 802.1D domain， the whole STP domain will run in 802.1D compatibility mode.
G.In partially migrated 802.1w networks， it is recommended to keep the STP diameter below 4.

最新試題

What is the next state of initial in spanning-tree protocol？

題型：問答題

Which of the following describes the roles of devices in a WAN?（）

題型：多項選擇題

QoS機制中的分類，采用ip數據包中的哪個字段？

題型：問答題

Refer to the exhibit.The network administrator is in acampus building distant from Building B.WANRouter is hosting a newly installed WAN link on interface S0/0.The new link is not functioning and the administrator needs to determine if the correct cable has been attached to the S0/0 interface.How can the administrator accurately verify the correct cable type on S0/0 in the most efficient manner?（）

題型：單項選擇題

hsrp speak狀態是什么意思？

題型：問答題

Which of the following are key characteristics of PPP?（）

題型：多項選擇題

Local Preference？

題型：問答題

什么問題導致SERVER VTP密碼跟替他交換機VTP密碼不匹配？

題型：問答題

A network administrator is troubleshooting the OSPF configuration of routers R1 and R2.The routers cannot establish an adjacency relationship on their common Ethernet link.The graphic shows the output of the show ip ospf interface e0 command for routers R1 and R2.Based on the information in the graphic,what is the cause of this problem?（）

題型：單項選擇題

four switches， which one will be root switch.（no pic）.

題型：問答題