A.PPP
B.WAP
C.HDLC
D.MPLS
E.L2TPv3
F.ATM
您可能感興趣的試卷
你可能感興趣的試題
A. ip default-gateway 0.0.0.0
B. ip route 172.16.2.1 0.0.0.0 0.0.0.0
C. ip default-network 0.0.0.0
D. ip default-route 0.0.0.0 0.0.0.0 172.16.2.1
E. ip route 0.0.0.0 0.0.0.0 172.16.2.1
A. Replace the straight-through cable with a crossover cable.
B. Change the subnet mask of the hosts to /25.
C. Change the subnet mask of the hosts to /26.
D. Change the address of Workstation A to 192.0.2.15.
E. Change the address of Workstation B to 192.0.2.111.
A.113.10.4.0
B.186.54.3.0
C.175.33.3.255
D.26.35.2.255
E.17.35.36.0
A.192.168.5.55
B.192.168.5.47
C.192.168.5.40
D.192.168.5.32
E.192.168.5.14
A.802.1Q giants frames could saturate the link.
B.VLAN10 on CAT1 and VLAN1 on CAT2 will send untagged frames.
C.A native VLAN mismatch error message will appear.
D.VLAN10 on CAT1 and VLAN1 on CAT2 will send tagged frames.
最新試題
What is the result of issuing the frame-relay map ip 192.168.1.2 202 broadcast command?()
Which IPsec security protocol should be used when confidentiality is required?()
A router receives information about network 192.168.10.0/24 from multiple sources.What will the router consider the most reliable information about the path to that network?()
Which command displays the CHAP authentication process as it occurs between two routers?()
Which statement describes the rule of split horizon?()
What is the purpose of the cisco Vlan Trunking protocol?()
If all OSPF routers in a single area are configured with the same priority value,what value dose a router use for the ODPF router ID in the absence of a loopback interface?()
An employee of ABC company has move to an office on a different floor. Although the administrator is able to telnet to all of the routers,the address of Switch F is needed in order to verify that the employee remains in the same VLAN.Which action could be used by the administrator to find the IP address of Switch F?()
After the show ip route command has been entered,the follwing routes are displayed.Which route will not be entered into the routing table of a neighboring router?()
The network administrator cannot to switch 1 over a telnet session,although the hosts attached to switch 1 can ping the interface Fa0/0 of the router.Given the information in the graphic and assuming that the router and switch2 are configured properly,which of the following commands should be issued on switch 1 to correct this problem?()