n1kv-l3（config）# show lacp offload status
Current Status ： Enabled
Running Config Status ： Enabled
Saved Config Status ： Disabled
What two facts does the output signify？ （）
A. LACP is enabled on the Nexus 1000v.
B. LACP will be offloaded to the upstream switch.
C. LACP will be negotiated to the VM.
D. LACP is negotiated by the VSM.
E. LACP is negotiated by the VEM in all instances.
您可能感興趣的試卷
你可能感興趣的試題
A. intelligent traffic steering to the VSG
B. offloading the processing from the VSG to the VEM
C. intelligent traffic steering to the VNMC
D. offloading the processing from the VSG to the flow manager
E. deep packet inspection
A. channel-group auto mode on
B. channel-group auto mode active
C. channel-group auto mode on sub-group cdp
D. channel-group auto mode on sub-group manual
E. channel-group auto mode on mac-pinning
A. accounting
B. authentication
C. authorization
D. network monitoring
E. network planning
A. 0
B. 1
C. 2
D. 3
E. 4
F. 5
When configuring vPC-HM CDP with multiple links to the same switch， are port-channels required？（）
A. Each link between the upstream switch and the VEM is an individual subgroup.
B. Connections that go to the same upstream switch must be configured with the command channel-group
C. Connections that go to the same upstream switch must be configured with the command channel-group
D. With vPC-HM CDP， the user can pin traffic from a specific VM to a specific uplink.
E. Connections that go to the same upstream switch must be configured with the command channel-group
最新試題
In a Cisco Unified Computing System， where are SAN port channels connected to？（）
Which of the following are supported in Cisco Global Site Selector？ （）
Server load balancing （SLB） is the process of deciding to which server a load-balancing device should send a client request for service. Which predictors are supported on ACE in order to select the best server to fulfill a client request？ （）
A Cisco UCS fabric interconnect in end-host mode learns MAC addresses on which port types？（）
Given the following output： san-port-channel 12 is up Hardware is Fibre Channel Port WWN is 24：0c：00：0d：ec：d3：5c：00 Admin port mode is NP， trunk mode is on Port mode is NP Port vsan is 1 Speed is 8 Gbps Member[1] ： fc2/3 Member[2] ： fc2/4 What does "Speed is 8 Gbps" indicate？（）
Refer to the exhibit. According to the equipment tab in Cisco UCS Manager， which is true？（）
What is the appliance port used to connect to in a Cisco Unified Computing System？（）
In a Cisco Unified Computing System， What is the "designated receiver" port in end-host mode used for？（）
A Cisco Application Control Engine Appliance （ACE） non-admin context does not support "sticky" configuration. What is the reason for this issue？（）
What would be the cause for the following fault in UCS Manager？（） "ether VIF x / xxx down， reason： ENM source pinning failed"