A.EIGRP will not be accepted when configured on the actual RIPv2 routers.
B.OSPF will no longer be used in the routing table, because you only have EIGRP internal routes running.
C.OSPF will no longer be used in the routing table, because you only have EIGRP external routes running.
D.RIPv2 will populate its RIP database but not its routing table, because you only have EIGRP external routes running.
E.RIPv2 will populate its RIP database but not its routing table, because you only have EIGRP internal routes running.
F.OSPF database will have RIPv2 routes.
您可能感興趣的試卷
你可能感興趣的試題
A.The trunking configuration mode on Switch1 is set to Off.
B.The trunking configuration mode on the other end is set to On.
C.The trunking configuration mode on the other end is set to Desirable.
D.Cisco Discovery Protocol is not running on the other end.
E.There is a VTP domain name mismatch.
F.Switch1 does not support 802.1Q
A.BGP peers must be Layer 2-adjacent.
B.EBGP multihop is not configured.
C.The firewall is not configured to allow IP protocol 89.
D.The firewall is not configured to allow UDP 179.
A.route redistribution
B.import and export using route descriptors
C.import and export using route targets
D.Cisco MPLS Traffic Engineering
A.CEF
B.FIB
C.LFIB
D.IGP
A.interface bandwidth
B.interface delay
C.interface bandwidth and delay
D.hop count
E.bridge priority
最新試題
Which three are needed to run VRF lite for IPv6 on a router? ()
You are the network administrator of a Layer 3 switched network. Users in one VLAN are complaining that access to the server VLAN is very slow from time to time. Traffic in the local VLAN works without any issue, and users in other VLANs do not have any complaint to reach the server VLAN. What is most likely the cause of this issue?()
What is the command to configure RSVP to reserve up to one-tenth of a Gigabit link, but only allow each individual flow to use 1 MB/s?()
What are the "bound IP addresses" used for in LDP?()
For the following ports, which port is on every bridge in a Spanning Tree Protocol IEEE 802.1w network except the root bridge?()
Phase I and Phase II DMVPN differ in terms of which of these characteristics?()
Which router is doing LSA type 7 to type 5 translation,and why?()
For the following items,what is the mathematical relationship between the committed information rate (CIR), committed burst (Bc), and committed rate measurement interval (Tc)?()
Which switch port error is an indication of duplex mismatches on 10/100/1000 IEEE 802.3u Gigabit Ethernet ports?()
Which QoS mechanism can help classify different kinds of Citrix traffic (print job versus real-time terminal control)?()