多項選擇題Which two of these elements need to be configured prior to enabling SSH? ()

A.hostname
B.loopback address
C.default gateway
D.domain name
E.SSH peer address


您可能感興趣的試卷

你可能感興趣的試題

1.多項選擇題The network administrator wants to enable an EtherChannel between two switches in "on" mode. The administrator connects the cables and enables the interfaces, but while configuring the EtherChannel in the first switch, a spanning-tree loop was detected. Which two of these  procedures can avoid this problem?()

A.Configure the EtherChannel as "desirable" first.
B.Assign all interfaces to the same VLAN.
C.Disable PortFast on the interfaces in the EtherChannels.
D.Disable all interfaces first.
E.Fast Ethernet and Gigabit Ethernet ports cannot be assigned to the same EtherChannel.
F.Fix cabling problems.

2.多項選擇題our company is researching a new application that runs over IPv6, but part of it must still have IPv4 support. Your company uses a traditional IPv4 network. Your plan is not to run IPv6 over the whole network, but to segment parts of the network or even to operate simultaneously with IPv6 and IPv4. You must make a brief presentation about IPv6 technology to the board of technical directors. Which three of these items could be part of your presentation?()

A.Tunnel IPv6 over IPv4 to connect far-end IPv6 networks.
B.Explain why configuring IPv4 and IPv6 at the same time over the same LAN interface is not possible.
C.Explain why configuring IPv4 and IPv6 at the same time over the same LAN interface is possible.
D.What is the meaning of EUI-64 and how does it work?
E.Tunnel IPv4 over IPv6 to connect far-end IPv4 networks.

3.多項選擇題Half of your network uses RIPv2 and the other half runs OSPF. The networks do not communicate with each other. Which two of these factors describe the impact of activating EIGRP over each separate part? ()

A.EIGRP will not be accepted when configured on the actual RIPv2 routers.
B.OSPF will no longer be used in the routing table, because you only have EIGRP internal routes running.
C.OSPF will no longer be used in the routing table, because you only have EIGRP external routes running.
D.RIPv2 will populate its RIP database but not its routing table, because you only have EIGRP external routes running.
E.RIPv2 will populate its RIP database but not its routing table, because you only have EIGRP internal routes running.
F.OSPF database will have RIPv2 routes.

4.多項選擇題he network administrator is trying to add Switch1 to the network, but the 802.1Q trunk is not  coming up. Switch1 was previously tested in the laboratory and its trunk configuration worked fine.  What are three possible causes of this problem?()

A.The trunking configuration mode on Switch1 is set to Off.
B.The trunking configuration mode on the other end is set to On.
C.The trunking configuration mode on the other end is set to Desirable.
D.Cisco Discovery Protocol is not running on the other end.
E.There is a VTP domain name mismatch.
F.Switch1 does not support 802.1Q

5.單項選擇題Two BGP peers connected through a routed firewall are unable to establish a peering relationship. What could be the most likely cause?()

A.BGP peers must be Layer 2-adjacent.
B.EBGP multihop is not configured.
C.The firewall is not configured to allow IP protocol 89.
D.The firewall is not configured to allow UDP 179.

最新試題

IEEE 802.1w is a Rapid Spanning Tree Protocol (RSTP) that can be seen as an evolution of the 802.1 standard. What are the port roles described by 802.1w?()

題型:單項選擇題

Internet Protocol version 6 (IPv6) is the next-generation Internet Layer protocol for packet-switched internetworks and the Internet. IPv6 router solicitation is()

題型:單項選擇題

In GLBP, which router will answer on client ARP requests?()

題型:單項選擇題

An administrator of a peer-to-peer server application reports that the maximum bandwidth that his application receives is 90 Mb/s. You have an 8-port,100-Mb/s EtherChannel bundle on the switching infrastructure between the two servers, resulting in a bidirectional throughput of more than what is recorded. Which two solutions would allow for more bandwidth for the application?()

題型:多項選擇題

Which one of the following potential issues is eliminated by using split horizon?()

題型:單項選擇題

Which message type is constructed and sent from an MSDP router to its MSDP peers when it  receives a PIM register message (knowing that the MSDP router is also configured as an RP for  the PIM domain)?()

題型:單項選擇題

Which IOS security feature is configured by the ip inspect inspection-name {in  out} command?()

題型:單項選擇題

Which switch port error is an indication of duplex mismatches on 10/100/1000 IEEE 802.3u  Gigabit Ethernet ports?()

題型:單項選擇題

Choose two commands that are required to enable multicast on a router, when it is known that the receivers use a specific functionality of IGMPv3.()

題型:多項選擇題

f a Cisco switch is configured with VTPv1 in transparent mode, what is done with received VTP advertisements?()

題型:單項選擇題