A.A sham-link is a logical link between PE routers that provides an OSPF adjacency between the PE routers and forwards customer traffic across it.
B.A sham-link is a logical link between PE routers that provides an OSPF adjacency between the PE routers and carries OSPF LSAs.
C.A sham-link is a logical link between PE routers that carries OSPF LSAs and forwards customer traffic across it.
D.A sham-link is a point-to-multipoint link that provides an OSPF adjacency between the PE routers and carries OSPF LSAs.
E.A sham-link is a point-to-multipoint link that provides an OSPF adjacency between the PE routers and forwards customer traffic across it.
您可能感興趣的試卷
你可能感興趣的試題
A.Both RTA and RTB will do LSA7/5 translation，since they are both NSSA ABRs
B.RTA will do LSA7/5 translation，since it has the lower router ID
C.RTB will do LSA7/5 translation，since it has the higher router ID
D.The redistributing router will do LSA7/5 translation，since it is within the NSSA
A.It enables provider edge （PE） specific checks on a router when the OSPF process is associated with the VRF
B.It disables provider edge （PE） specific checks on a router when the OSPF process is associated with the VRF
C.It enables the exchange of the "VRF-Lite" capability when the OSPF adjacency is formed.
D.It disables the MPLS processing on the OSPF learned routes inside the VRF
A.OSPF external LSAs are automatically flooded into all OSPF areas, unlike type 7 LSAs, which require that redistribution be configured.
B.External LSAs (type 5) are automatically changed to type 1 LSAs at ASBRs.
C.Type 5 LSAs are route summaries describing routes to networks outside the OSPF Autonomous System.
D.External network LSAs (type 5) redistributed from other routing protocols into OSPF are not permitted to flood into a stub area
A.Before sending traffic, it must first join multicast group 239.1.1.1 by sending an IGMPv2 membership report to the default router on the local subnet.
B.It must send an IGMPv2 Request to Send packet and then wait for an IGMPv2 Clear to Send packet from the IGMPv2 querier router on the local subnet
C.It may begin transmitting multicast traffic to the group only when there is no other host transmitting to the group on the local subnet.
D.It may transmit multicast traffic to the group at any time.
A.00000
B.12345
C.23456
D.65000
E.99999
最新試題
Phase I and Phase II DMVPN differ in terms of which of these characteristics？（）
What is the command to configure RSVP to reserve up to one-tenth of a Gigabit link， but only allow each individual flow to use 1 MB/s？（）
For the following protocols， which one provides a mechanism to transparently intercept and redirect CIFS traffic from a client to a local Cisco Wida Area Application engine？（）
Multicast is being deployed in the network， and only ip pim sparse-dense mode has been configured on all interfaces in the network to support a new video streaming application. No other multicast configuration was applied anywhere in the network. Since enabling multicast， the network monitoring tools show periodic spikes in link utilization throughout the network， even in areas where the video application is not being used. What could be a possible cause？（）
Two directly connected routers， R1 and R2， are both configured for OSPF graceful restart. R2 is able to switch packets in hardware， but R1 is not. If a network administrator logs on to R2 and performs a system reload， which will be the result？（）
You are the network administrator of a Layer 3 switched network. Users in one VLAN are complaining that access to the server VLAN is very slow from time to time. Traffic in the local VLAN works without any issue， and users in other VLANs do not have any complaint to reach the server VLAN. What is most likely the cause of this issue？（）
In GLBP， which router will answer on client ARP requests？（）
What does a unicast prefix-based IPv6 multicast address start with？（）
You are the network administrator of an enterprise company that just deployed a global IP telephony environment. In order to guarantee good voice quality， you asked your provider to implement QoS on the CE routers of your MPLS network. On your LAN， you have also deployed QoS. Users， however， keep complaining about bad voice quality， and the provider does not see matches on the DSCP values that you have asked him to match upon. What is most likely the problem？（）
Which two attributes need to match for two switches to become members of the same MST region？ （）