A.the table of 4096 elements that map the respective VLAN to STP instance number
B.VTP version
C.configuration revision number
D.native VLAN ID
您可能感興趣的試卷
你可能感興趣的試題
A.PIM sparse mode is being used.
B.PIM dense mode is being used.
C.The BGP multicast address family has not been configured.
D.IGMP version 3 is being used.
E.IP PIM neighbor filters have not been applied.
A.The phones are not sending traffic with the correct DSCP value.
B.The Cisco CallManager is not marking the traffic correctly.
C.This is most likely a bug on the CE routers.
D.Your LAN QoS is incorrectly configured.
A.routing issue
B.denial-of-service attack
C.MAC flooding
D.spanning-tree recalculation
E.Layer 2 loop
F.ARP spoofing attack
A.LDAP
B.ICMP
C.RTP
D.BGP
E.SSH
F.RDP
A.qos-group
B.DSCP
C.LFI
D.NBAR
最新試題
Internet Protocol version 6 (IPv6) is the next-generation Internet Layer protocol for packet-switched internetworks and the Internet. IPv6 router solicitation is()
Two directly connected routers, R1 and R2, are both configured for OSPF graceful restart. R2 is able to switch packets in hardware, but R1 is not. If a network administrator logs on to R2 and performs a system reload, which will be the result?()
Which three protocols should be explicitly managed by using Control Plane Policing on an Internet border router?()
Which statement is correct about an OSPF sham-link?()
Policy-based routing allows network administrators to implement routing policies to allow or deny paths based on all of these factors except which one?()
Which three are needed to run VRF lite for IPv6 on a router? ()
What is the command to configure RSVP to reserve up to one-tenth of a Gigabit link, but only allow each individual flow to use 1 MB/s?()
IEEE 802.1w is a Rapid Spanning Tree Protocol (RSTP) that can be seen as an evolution of the 802.1 standard. What are the port roles described by 802.1w?()
You are the network administrator of an enterprise company that just deployed a global IP telephony environment. In order to guarantee good voice quality, you asked your provider to implement QoS on the CE routers of your MPLS network. On your LAN, you have also deployed QoS. Users, however, keep complaining about bad voice quality, and the provider does not see matches on the DSCP values that you have asked him to match upon. What is most likely the problem?()
Which three statements are true about policing? ()