A.IEEE 802.10
B.Misconfigured NIC
C.User configuration
D.IEEE 802.1Q
E.None of the other alternatives apply
您可能感興趣的試卷
你可能感興趣的試題
A VTP domain has six active VLANs. Without notice， all VLANs except VLAN1 fail. Just prior tothe failure， Switch2 was added to the network.
Which three issues on Switch2 could be the cause？（）
A.Switch2 is configured for only VLAN1
B.Switch2 is a VTP server in a different domain
C.Switch2 is a VTP server in the Company domain
D.Switch2 is not a VTP domain.
E.Switch2 has a lower VTP configuration revision number than the current VTP revision
F.Switch2 has a higher VTP configuration revision number than the current VTP revision
A.Physical management of the switch
B.Logical management of the switch
C.In-band management of the switch
D.Out-of-band management of the switch
A.Reload the active VLAN configuration
B.Clear the affected port and bring it up again
C.Explicitly set the trunk for the VLAN to be on
D.Remove all the VLANs set
A.The link is using IEEE 802.1Q protocol
B.The link is using IEEE 802.1E protocol
C.Spanning tree is disabled
D.Not enough information to determine
E.The native VLAN information is identical at each end of the link
F.The native VLAN information is different at each end of the link
A.IEEE 802.1Q
B.IEEE 802.10
C.Misconfigured NIC
D.User configuration
E.All of the above
最新試題
Match the xDSL type on the above to the most appropriate implementation on the below.
You need to configure a GRE tunnel on a IPSec router. When you are using the SDM to configurea GRE tunnel over IPsec， which two parameters are required when defining the tunnel interfaceinformation？（）
Drag the IOS commands from the left that would be used to implement a GRE tunnel using the10.1.1.0.30 network on interface serial 0/0 to the correct target area on the right.
This item contains several questions that you must answer. You can view these questions byclicking on the Questions button to the left. Changing questions can be accomplished by clicking the numbers to the left of each question. In order to complete the questions， you will need to referto the SDM and the topology， neither of which is currently visible.To gain access to either the topology or the SDK click on the button to left side of the screen thatcorresponds to the section you wish to access. When you have finished viewing the topology theSDK you can return to your questions by clicking on the Questions button to the left.Which defined peer IP address an local subnet belong to Crete？（）
Study the exhibit carefully.Routers A and B are customer routers. Routers 1， 2， 3 and 4 are provider routers. The routers areoperating with various IOS versions. Which frame mode MPLS configuration statement is true？（）
Refer to the exhibit. Which two statements about the AAA configuration are true？（）
Drag and drop the steps in the process for provisioning a cable modem to connect to a headendon the above to the below in the order defined by the DOCSIS standard.
As a network technician， do you know what is a recommended practice for secure configurationmanagement？（）
IPSec VPN is a widely-acknowledged solution for enterprise network. Which three IPsec VPNstatements are true？（）
As a network engineer， do you know for what purpose SDM uses Security Device Event Exchange（SDEE）？（）