Look at the graphic below， the connectivity between Cisco IP phone access port and theworkstation CK-PC has been established， how to manage the traffic？（）
A.The IP phone access port will override the priority of the frames received from the CK-PC
B.The IP phone access port would trust the priority of the frames received from the CK-PC
C.The switch port FaO/4 would neglect the priority of the frames received from the CK-PC
D.The switch port FaO/4 would trust the priority for the frames received from the CK-PC
您可能感興趣的試卷
你可能感興趣的試題
An IP phone connects a user to a switch as shown below：
Based on the diagram shown above， which statement is true about the voice traffic coming to theswitch access port that is connected to the IP phone？（）
A.A PC connected to a switch port via an IP phone is unaware of the presence of the phone
B.The traffic on the voice VLAN must be tagged with 802.1p encapsulation in order to coexist onthe same LAN segment with a PC
C.To improve the quality of the voice traffic， no other devices should be attached to the IP phone
D.The voice VLAN must be configured as a native VLAN on the switch
E.A PC connected to a switch port via an IP phone must support a trunking encapsulation
A.Antenna power is a relative value reference to dBi
B.LWAPP allows encrypted communications between lightweight access points and WLANcontrollers.
C.Characteristics of antennas are directionality， gain， and polarization
D.Power over Ethernet （PoE） is only available when a WLAN controller is integrated into thenetwork
E.The WLAN solution Engine （WLSE） is used to control lightweight access points
F.One of the advantages of the lightweight WLAN solution is that the devices act indepently
Network topology exhibit：
In this WLAN segment， what are three requirements for configuring these Aironet access points（APs） that will allow for all wireless clients to work without service interruption while roaming fromaccess point to access point？（）
All access points should be configured....
A....with a unique IP subnet range
B....with identical SSIDs
C....within the same IP subnet
D....with the same guest mode SSID
E....only with the native VLAN
F....with the native VLAN
A.association request/response， probe request/response， authentication request/response
B.association request/response， authentication request/response， probe request/response
C.probe request/response， authentication request/response， association request/response
D.probe request/response， association request/response， authentication request/response
E.None of the other alternatives apply
Exhibit：
In this scenario the signal transmitted from the AP is reflected off a wall， resulting in multipathinterference at the client end （ClientA）. Which of the following statements is true？（）
A.The transmitted signal from the AP arrives at the client at slightly different times resulting inphase shifting
B.Multipath interference can be solved by using dual antennas
C.If signal 2 is close to 360 degrees out of phase with signal 1， the result is essentially zero signalor a dead spot in the WLAN
D.Multipath interference is less of an issue when using a DSSS technology because multipath isfrequency selective
E.If signal 1 is in phase with signal 2， the result is essentially zero signal or a dead spot in theWLAN
F.None of the other alternatives apply
最新試題
Drag and drop each management protocol on the above to the correct category on the below.
Drag the correct statements about MPLS-based VPN on the left to the boxes on the right.（Not allstatements will be used）
cisco ios command to interface dialer 0
Which three statements accurately describe IOS Firewall configurations？（）
Drag the DSL local loop topic on the left to the correct descriptions on the right.
IPSec VPN is a widely-acknowledged solution for enterprise network. Which three IPsec VPNstatements are true？（）
A new router was configured with the following commands：The configuration above was found on an Internet Service Provider’s （ISP） Multiprotocol LabelSwitching （MPLS） network. What is its purpose？（）
Drag the IOS commands from the left that would be used to implement a GRE tunnel using the10.1.1.0.30 network on interface serial 0/0 to the correct target area on the right.
Drag and drop the xDSL type on the above to the appropriate xDSL description on the below.
Drag each element of the Cisco IOS Firewall Feature Set from the above and drop onto itsdescription on the below.