A.The access layer is the initial point at which traffic enters the network. Traffic is marked (orremarked) at Layers 2 and 3 by the access switch as it enters the network, or is "trusted" that it isentering the network with the appropriate tag
B.No traffic marking occurs at the core layer. Layer 2/3 QoS tags are trusted from distributionlayer switches and used to prioritize and queue the traffic as it traverses the core
C.Traffic inbound from the access layer to the distribution layer can be trusted or reset dependingupon the ability of the access layer switches. Priority access into the core is provided based onLayer 3 QoS tags
D.IP precedence, DSCP, QoS group, IP address, and ingress interface are Layer 2 characteristics that are set by the access layer as it passes traffic to the distribution layer. Thedistribution layer, once it has made a switching decision to the core layer, strips these off
E.MAC address, Multiprotocol Label Switching (MPLS); the ATM cell loss priority (CLP) bit, theFrame Relay discard eligible (DE) bit, and ingress interface are established by the voicesubmodule (distribution layer) as traffic passes to the core layer
F.The distribution layer inspects a frame to see if it has exceeded a predefined rate of trafficwithin a certain time frame, which is typically a fixed number internal to the switch. If a frame isdetermined to be in excess of the predefined rate limit, the CoS value can be marked up in a waythat results in the packet being dropped
您可能感興趣的試卷
你可能感興趣的試題
A.QoS classified at layer 3 using IP precedence or DSCP
B.Guaranteed rate service
C.Implemented using FIFO queues
D.All traffic has an equal chance of being dropped
A.Quality of Service (QoS)
B.Intelligent platforms
C.Mobility and scalability
D.Security
E.High availability
A.The use of a queuing method that will give VoIP traffic strict priority over other traffic
B.The use of RTP header compression for the VoIP traffic
C.The proper classification and marking of the traffic as close to the source as possible
D.The use of 802.1QinQ trunking for VoIP traffic
E.The use of WRED
A.IP phones require inline power and must be in separate VLAN to receive inline power
B.IP telephony applications require prioritization over other traffic as they are more delaysensitive
C.IP phones can only receive IP addresses through DHCP if they are in separate VLAN
D.The CDP frames from the IP phone can only be recognized by the switch if the phone is in anauxiliary vlan
According to the information presented in the following exhibit, can you tell me the reason that thetrust state of interface FastEthernet 0/3 displays "not trusted"?()
A.The command mis qos needs to be turned on in global configuration mode
B.DSCP map needs to be configured for VOIP
C.ToS has not been configured
D.There is not a Cisco Phone attached to the interface
最新試題
Drag the IPsec protocol description from the above to the correct protocol type on the below.(Notall descriptions will be used)Drag and Drop question, drag each item to its proper location.
Router NetworkTut is configured as shown below:Given the above configuration, which statement is true?()
Which statement correctly describes IPsec VPN backup technology?()
Drag the IOS commands from the left that would be used to implement a GRE tunnel using the10.1.1.0.30 network on interface serial 0/0 to the correct target area on the right.
As a network technician, do you know what is a recommended practice for secure configurationmanagement?()
You need to configure a GRE tunnel on a IPSec router. When you are using the SDM to configurea GRE tunnel over IPsec, which two parameters are required when defining the tunnel interfaceinformation?()
Which three statements accurately describe IOS Firewall configurations?()
This item contains several questions that you must answer. You can view these questions byclicking on the Questions button to the left. Changing questions can be accomplished by clicking the numbers to the left of each question. In order to complete the questions, you will need to referto the SDM and the topology, neither of which is currently visible.To gain access to either the topology or the SDK click on the button to left side of the screen thatcorresponds to the section you wish to access. When you have finished viewing the topology theSDK you can return to your questions by clicking on the Questions button to the left.Which defined peer IP address an local subnet belong to Crete?()
Study the exhibit carefully.Routers A and B are customer routers. Routers 1, 2, 3 and 4 are provider routers. The routers areoperating with various IOS versions. Which frame mode MPLS configuration statement is true?()
Drag and drop each function on the above to the hybrid fiber-coaxial architecture component that itdescribes on the below.