A.All traffic is tagged with a specific VLAN ID from the VLAN of the attacker and is now viewable
B.Clients will forward packets to the attacking device, which will in turn send them to the desireddestination but not before recording the traffic patterns
C.All traffic is redirected to the VLAN that the attacker used to flood the CAM table
D.All traffic is flooded out all ports and an attacker is able to capture all data
E.None of the other alternatives apply
您可能感興趣的試卷
你可能感興趣的試題
A.MAC spoofing
B.VLAN hopping
C.MAC address flooding
D.DHCP flooding
E.Session hijacking
A.Enable BPD guard
B.Disable CDP on ports where it is not necessary
C.Place unused ports in a common unrouted VLAN
D.Prevent automatic trunk configuration
E.Implement port security
Refer to the exhibit. Based upon the configuration, you need to understand why the policy routingmatch counts are not increasing. Which would be the first logical step to take?Select the bestresponse.()
A.Confirm if there are other problematic route-map statements thatprecede divert
B.Check the access list for log hits
C.Check the routing table for 212.50.185.126
D.Remove any two of the set clauses(Multiple set clause entries will cause PBR to use therouting table.)
Study the following graphic carefully Host1 and Host2, which belong to different VLANs, are in thesame subnet. According to the information displayed, which description is correct when trying toping from host to host?()
A.A trunk port should be configured on the link between CK-SW1 and CK-SW2 to pingsuccessfully
B.The two hosts should be in the same VLAN in order to ping successfully
C.A Layer 3 device is a must in order for the ping command to be successful
D.The ping command will be successful without any further configuration changes
Refer to the exhibit. VLAN2, VLAN3, and VLAN10 are configured on the switch D-SW1.Host computers are on VLAN 2 (10.1.2.0), servers are on VLAN 3 (10.1.3.0), and the
management VLAN is on VLAN10 (10.1.10.0). Hosts are able to ping each other but are unable toreach the servers. On the basis of the exhibited output, which configuration solution could rectifythe problem?()
A.Enable IP routing on the switch D-SW1
B.Configure a default route that points toward network 200.1.1.0/24
C.Assign an IP address of 10.1.3.1/24 to VLAN3
D.Configure default gateways to IP address 10.1.2.1 on each host
E.Configure default gateways to IP address 10.1.10.1 on each host
F.Configure default gateways to IP address 200.1.1.2 on each host
最新試題
As a network technician, do you know what is a recommended practice for secure configurationmanagement?()
Drag and drop the steps in the process for provisioning a cable modem to connect to a headendon the above to the below in the order defined by the DOCSIS standard.
Study the exhibit carefully. The Cisco IOS IPsec High Availability (IPsec HA) Enhancementsfeature provides an infrastructure for reliable and secure networks to provide transparent availability of the VPN gateways - that is, Cisco IOS Software-based routers. What are the twooptions that are used to provide High Availability IPsec?()
Network Topology Exhibit:Configuration Exhibit:NET(config)# access-list 112 deny icmp any any echo logNET(config)# access-list 112 deny imp any any redirect logNET(config)# access-list 112 deny icmp any any mask-request logNET(config)# access-list 112 permit icmp any 10.1.1.0 0.0.0.255NET(config)# interface Fa0/1NET(config-if)# ip access-group 112 inYou work as a network administrator at networkTut.com, study the exhibit carefully. Theconfiguration has been applied to router NET to mitigate the threat of certain types of ICMPbasedattacks while allowing some ICMP traffic to the corporate LAN to work. However, the configurationis incorrect. On the basis of the information in the exhibit, which configuration option wouldcorrectly configure router NET?()
Drag each element of the Cisco IOS Firewall Feature Set from the above and drop onto itsdescription on the below.
Drag the correct statements about MPLS-based VPN on the left to the boxes on the right.(Not allstatements will be used)
This item contains several questions that you must answer. You can view these questions byclicking on the Questions button to the left. Changing questions can be accomplished by clickingthe numbers to the left of each question. In order to complete the questions, you will need to referto the SDM and the topology, neither of which is currently visible. To gain access to either thetopology or the SDK click on the button to left side of the screen that corresponds to the sectionyou wish to access. When you have finished viewing the topology the SDK you can return to yourquestions by clicking on the Questions button to the left.Which IPSec rule is used for the Olympia branch and what does it define?()
Router NetworkTut is configured as shown below:Given the above configuration, which statement is true?()
Drag and drop the xDSL type on the above to the appropriate xDSL description on the below.
In computer security, AAA stands for authentication, authorization and accounting. Which optionabout the AAA authentication enable default group radius enable command is correct?()