A.Link-local address used for next-hop addresses
B.Interface can be added to RIP routing process in either interface configuration mode or in routerconfiguration mode
C.Uses a multicast to send routing updates
D.Use hop count as a metric
E.Distance-vector routing protocol
F.Maximum hop count is 15 with 16 being "unreachable"
您可能感興趣的試卷
你可能感興趣的試題
A.The default-metric command configured under the appropriate interface
B.The metric parameter in the network command of a routing process
C.The metric parameter in the redistribute command
D.The default-metric command
E.A route-map containing a seed command
F.A route map containing a metric command
A.Designated port
B.Nonswitch port
C.Switch port
D.Nonroot port
E.Nondesignated port
F.Root port
A.show ip eigrp topology
B.show ip eigrp adjacency
C.show ip eigrp routes
D.show ip eigrp database
E.show ip route eigrp
F.show ip eigrp forwarding
A.255.255.255.255
B.224.0.0.6
C.FFFF：FFFF：FFFF：FFFF：FFFF：FFFF：FFF：FFF
D.FF02：：10
E.224.0.0.10
F.FF02：：5
A.Rl（config-if）#ipv6 default-information originate
B.Rl（config-router）#ipv6 rip 〈process-name〉 default-information only
C.Rl（config）#ipv6 route ：：/0 null 0
D.Rl（config-if）#ipv6 rip 〈process-name〉 default-information only
E.Rl（config-router）#ipv6 rip route ；：/0 originate
F.Rl（config-router）#aggregate-address ：：/0 summarize-routes
最新試題
As a network engineer， do you know for what purpose SDM uses Security Device Event Exchange（SDEE）？（）
As a network technician， do you know what is a recommended practice for secure configurationmanagement？（）
Drag the correct statements about MPLS-based VPN on the left to the boxes on the right.（Not allstatements will be used）
Router NetworkTut is configured as shown below：Given the above configuration， which statement is true？（）
Match the xDSL type on the above to the most appropriate implementation on the below.
IPSec VPN is a widely-acknowledged solution for enterprise network. Which three IPsec VPNstatements are true？（）
cisco ios command to interface dialer 0
A new router was configured with the following commands：The configuration above was found on an Internet Service Provider’s （ISP） Multiprotocol LabelSwitching （MPLS） network. What is its purpose？（）
Drag the protocols that are used to distribute MPLS labels from the above to the target area on thebelow.（Not all options will be used）
Drag the DSL technologies on the left to their maximum（down/up） data rate values on the below.