Refer to the exhibit.
Which statement is true when voice traffic is forwarded on the same VLAN used by the data traffic? ()
A.The voice traffic cannot be forwarded to the distribution layer.
B.The voice traffic cannot use 802.1p priority tagging.
C.Port security cannot be enabled on the switch that is attached to the IP phone.
D.Quality of service cannot be applied for the voice traffic.
您可能感興趣的試卷
你可能感興趣的試題
Refer to the exhibit.
Why does the trust state of interface FastEthernet 0/3 show "not trusted"? ()
A.DSCP map needs to be configured for VOIP.
B.ToS has not been configured.
C.ToS has been misconfigured.
D.The command mls qos needs to be turned on in global configuration mode.
E.There is not a Cisco Phone attached to the interface.
Refer to the exhibit.
What statement is true about the configuration on switch CAT1?()
A.The configuration establishes policed DSCP on ports Fa0/11 and Fa0/12 with values ranging from 8 to 56.
B.The configuration overrides 802.1p priorities on packets entering ports Fa0/11 and Fa0/12 with a value of 48.
C.Untagged Port VLAN ID (PVID) frames will carry voice traffic on VLAN 40.
D.Two IP phones with the MAC addresses of 0008.8595.d1a7 and 0007.8595.d2b7 are connected to CAT1 ports Fa0/11 and Fa0/12, respectively.
E.Security violation shutdown mode has been activated for ports Fa0/11 and Fa0/12.
F.The configuration overrides the Quality of Service value in packets entering ports Fa0/11 and Fa0/12 with a value of 45.
You need to configure a new Cisco router to be installed in the Company VOIP network.
Which three interface commands will configure the switch port to support a connected Cisco phone and to trust the CoS values received on the port if CDP discovers that a Cisco phone is attached? ()
A.switchport voice vlan vlan-id
B.mls qos trust device cisco-phone
C.switchport priority extend cos_value
D.mls qos trust cos
E.mls qos trust override cos
Refer to the exhibit.
Which three statements are true about trust boundaries in the campus network?()
A.Classification and markingoccur using 802.1ab QoS bits before reaching the trust boundary.
B.A device is trusted if it correctly declassifies packets.
C.A device is trusted if it correctly classifies packets.
D.Network trust boundaries are automatically configured in IOS version 12.3 and later.
E.The outermost trusted devices represent the trust boundary.
F.For scalability, classification should be done as close to the edge as possible.
Refer to the exhibit.
Which two statements are true about the required switch configurations to support a voice VLAN?()
A.CDP must be disabled on the switch port to prevent interference between CDP messages and voice traffic.
B.Port security cannot be configured on a port that is configured for a voice vlan.
C.Static secure MAC addresses should be configured on voice vlan ports to prevent access by devices other than IP phones.
D.CDP must be enabled on the switch port to allow configuration information to be passed to the IP phone.
E.Portfast must be enabled on the switch port.
F.802.1x authentication cannot be configured on a port configured for a voice vlan.
最新試題
What will occur when a nonedge switch port that is configured for Rapid Spanning Tree does not receive a BPDU from its neighbor for three consecutive hello time intervals?()
DS2 has not become the active device for Vlan103’s HSRP group even though all interfaces are active. As related to Vlan103’s HSRP group. What can be done to make the group function properly ? ()
During routine maintenance, it became necessary to shutdown G1/0/1 on DS1 and DS2. All other interface were up. During this time, DS1 became the active device for Vlan104’s HSRP group. As related to Vlan104’s HSRP group. What can be done to make the group function properly ? ()
Refer to the exhibit. Which Virtual Router Redundancy Protocol (VRRP) statement is true about the roles of the master virtual router and the backup virtual router?()
Refer to the exhibit and the partial configuration of switch SW_A and SW_B. STP is configured on all switches in the network. SW_B receives this error message on the console port:00:06:34: %CDP-4-DUPLEX_MISMATCH: duplex mismatch discovered on FastEthernet0/5 (not half duplex), with SW_A FastEthernet0/4 (half duplex) , with TBA05071417(Cat6K-B) 0/4 (half duplex). What would be the possible outcome of the problem?()
During routine maintenance, G1/0/1 on DS1 was shutdown. All other interface were up. DS2 became the active HSRP device for Vlan101 as desired. However, after G1/0/1 on DS1 was reactivated. DS1 did not become the active HSRP device as desired. What need to be done to make the group for Vlan101 function properly ? ()
Refer to the exhibit. What does the command channel-group 1 mode desirable do? ()
Refer to the exhibit. On the basis of the output of the show spanning-tree inconsistentports command, which statement about interfaces FastEthernet 0/1 and FastEthernet 0/2 is true?()
Refer to the exhibit. The command switchport mode access is issued on interface FastEthernet0/13 on switch CAT1. What will be the result?()
Refer to the exhibit. Switch 15 is configured as the root switch for VLAN 10 but not for VLAN 20. If the STP configuration is correct, what will be true about Switch 15?()