A policy needs to be implemented on Router B so that any traffic sourced from 172.16.10.0/24 will be forwarded to Router C. Which configuration on Router B will achieve the desired effect?（）
A.access - list 1 permit 172.16.10.0 0.0.0.255 ! interface e0 ip policy route - map policy ! route - map policy permit 10 match ip address 1 set ip next - hop 1 72.16.14.4
B.access - list 1 permit 172.16.10.0 0.0.0.255 ! interface s0 ip policy route - map policy ! route - map policy permit 10 match ip address 1 set ip next - hop 172.16.12.3
C.access - list 1 permit 172.16.10.0 0.0.0.255 ! interface e0 ip polic y route - map policy ! route - map policy permit 10 match ip address 1 set ip next - hop 172.16.12.2
D.access -list 1 deny 172.16.10.0 0.0.0.255 ! interface s0 ip policy route - map policy ! route - map policy permit 10 match ip address 1 set ip next - hop 172.16.12.2
您可能感興趣的試卷
你可能感興趣的試題
During the redistribution process configured on RTA, some of the EIGRP routes, such as 10.1.1.0/24 and 10.2.2.0/24,are not being redistributed into the OSPF routing domain. Which two items could be a solution to this proble m?（）
A. Change the EIGRP AS number from 100 to1 in the redistribute command.
B. Add the subnets option to the redistribute command.
C. Change the metric - type to2 in the redistribute command.
D. Configure the redistribute command under router eigrp 1 i nstead.
E. Change the metric to an EIGRP compatible metric value (bandwidth, delay, reliability, load, MTUs) in the redistribute command.
A. 39.0f01.0002.0000.0c00.1111.00
B. 48.0f01.0002.0000.0c00.1111.00
C. 49.0004.30ac.0000.3090.c7df.00
D. 52.0f01.0002.0000. 0c00.1111.00
A. IGMP
B. IGMP snooping
C. PIM - DM
D. DVMRP
E. MOS PF
Refer to the exhibit. Which command would verify if PBR reacts to packets sourced from 172.16.0.0/16?（）
A. show ip route
B. show policy - map
C. show access - lists
D. show route - map
A. Areas introduce a boundary on the link - state updates.
B. Areas are logical definitions specific to any given router.
C. All routers within an area have the exact link - state database.
D. The calculation of the Dijkstra algorithm on a router is limited to changes within an area.
E. The area designated router will always have a priority of 0.
最新試題
Router R1 connects to Router R2 over an Ethernet LAN with both routers using their F0/0 interfaces. R1 learns a route from R2 using EIGRP f or IPv6. That route lists F0/0 as the outgoing interface with R2 as the next hop. The configuration excerpt shows all relevant configuration on R2's F0/0 interface. Which of the following is true about R1's route?（）interface f0/0mac - address 1111.1111.1 111ipv6 address 2000::/64 eui - 64ipv6 address 2001::1/64
The answers each list a tunnel method and two consecutive IPv6 address quartets.Which answers identify a tunneling method that relies on an IPv4 address to be embedded into an IPv6 address, within the correct quartets listed?（）
Router R1, a branch router, connects to the Internet using DSL. Some traffic flows through a GRE and IPsec tunnel, over the DSL connection, destined for an Enterprise network.Which of the following answers best describes the router's logic that tells the router, for a given packet, to apply GRE encapsulation to the packet?（）
Router R1 has been conf igured with an ipv6 route 2000::/64 S0/0/0 64 command.Which of the following does the 64 at the end of the command represent?（）
An enterprise has plans to start adding IPv6 support. The initial deployment requires support from some IPv6 - only device s that need to access servers that support only IPv4.Which of the following tools would be most appropriate?（）
Router R1 has two LAN interfaces and three serial interfaces enabled for IPv6. All the inte rfaces use link local addresses automatically generated by the router.Which of the following could be the link local address of R1's interface S0/0?（）
Router R1 currently has no configuration related to IPv6 or IPv4. The following configuration exists in a planning document, intended to be used to copy/paste into Router R1 to enable OSPFv3 on interfaces F0/0 and S0/0/0. No other related configuration exists. Assuming F0/0 and S0/0/0 reach an up/up state, which of the following is true about OSPFv3 on R1 after this configuration has been pasted into R1?（）ipv6 router ospf 1ipv6 unicast- routinginterface f0/0ipv6 address 2000 ::1/64ipv6 ospf 1 area 1interface s0/0/0ipv6 address 2001::/64 eui - 64ipv6 ospf 1 area 0
Which of the following answers lists either a protocol or function that can be used by a host to dynamically learn its own IPv6 address?（）
An engineer is reviewing another engineer's sample configuration for a GRE tunnel used to pass IPv6 traffiC. The tunnel ha s not yet been configured on the router.Which of the following commands is not required for the configuration to pass IPv6 traffic?（）
Router R1 currently has no configuration related to IPv6 or IPv4. The following configuration exis ts in a planning document intended to be used to copy/paste into Router R1 to enable EIGRP for IPv6 on interfaces F0/0 and S0/0/0. No other related configuration exists. Assuming F0/0 and S0/0/0 reach an up/up state, which of the following is true about EIGRP for IPv6 on R1 after this configuration has been pasted into R1?（）ipv6 router eigrp 1ipv6 unicast- routinginterface f0/0ipv6 address 2000::1/64ipv6 eigrp 1interface s0/0/0ipv6 address 2001::/64 eui - 64ipv6 eigrp 1