A. forms adjacencies with all neighbors
B. supports demand circuit routing
C. provides routing support for multiple network layer protocols
D. utilizes SPF algorithm
E. provides for network scalability by allowing the network to be separated into areas
F. three layers of hierarchical routing
您可能感興趣的試卷
你可能感興趣的試題
A. Internet Protocol address
B. Media Access Control address
C. Packet Layer Proto col address
D. Network Service Access Point address
E. Authority and Format Identifier address
A. The cost is set to 10 for all interfaces.
B. The cost is set to 10 for LAN interfaces and 20 for WAN interfaces.
C. The cost is based on the speed of the interface.
D. The cost is based o n a composite of bandwidth and delay of the interface.
A. complete SNP (CSNP)
B. partial SNP (PSNP)
C. hello
D. database query
E. database description packet (DDP)
A. complete SNP (CSNP)
B. partial SNP (PSNP)
C. database query
D. database description packet (DDP)
E. link - state summary
F. hello
A. Configure the net system - id command under routerisis and enable IS - IS on each interface with the ip router isis command.
B. Configure the net sy stem - id and the network net - id commands under routerisis.
C. Configure the network net - id command(s) under routerisis and enable IS - IS on each interface with the ip router isis command.
D. Configure the network net - id command(s) and the is - type level -1- 2 command under routerisis.
E. Configure the net system - id and the network net - id commands under routerisis and enable ISIS on each interface with the ip router isis command.
最新試題
Which of the following must match for two directly connected routers running OSPF to establish a neighbor adjacency?（）
Router R1, a branch router, connects to the Internet using DSL. Some traffic flows through a GRE and IPsec tunnel, over the DSL connection, destined for an Enterprise network.Which of the following answers best describes the router's logic that tells the router, for a given packet, to apply GRE encapsulation to the packet?（）
Router R1 currently has no configuration related to IPv6 or IPv4. The following configuration exis ts in a planning document intended to be used to copy/paste into Router R1 to enable EIGRP for IPv6 on interfaces F0/0 and S0/0/0. No other related configuration exists. Assuming F0/0 and S0/0/0 reach an up/up state, which of the following is true about EIGRP for IPv6 on R1 after this configuration has been pasted into R1?（）ipv6 router eigrp 1ipv6 unicast- routinginterface f0/0ipv6 address 2000::1/64ipv6 eigrp 1interface s0/0/0ipv6 address 2001::/64 eui - 64ipv6 eigrp 1
Router R1 sits at an Enterprise branch office, using both the Internet and a leased line to another Enterprise router for its two connectivity options back into the rest of the Enterprise network. The engineer planning for this branch decided to use the leased line for all Enterprise traffic, unless it fails, in which case the Internet connection should be used to pass traffic to the Enterprise.Which of the following is most likely to be useful on the branch router?（）
The following configura tion exists on a router on one end of an IPv6 tunnel. Which type of tunnel is created by this configuration?（）interface loopback 1ip address 1.1.1.1 255.255.255.255interface tunnel 2ipv6 address 2000::1::/64tunnel source loopback 1tunnel destina tion 2.2.2.2tunnel mode ipv6ipipv6 eigrp 1
Which of the following is helpful to allow an IPv6 host to learn the IP address of a default gateway on its subnet?（）
Router R1 sits at an Enterprise branch office, using the Internet for its only connectivity back to the rest of the EnterprisE.Which of the following is not a ben efit of using an IPsec tunnel for packets sent through the Internet, between R1 and the rest of the Enterprise?（）
An Enterprise rou ter, Ent1, displays the following excerpt from the show ip bgp command. ENT1 has an eBGP connection to an ISP router with address 3.3.3.3 and an iBGP connection to a router with address 4.4.4.4. Which of the following is most likely to be true?（）Network Next Hop Metric LocPrf Weight Path*> 3.3.3.3 0 0 1 1 1 1 218 i
An engineer is reviewing another engineer's sample configuration for a GRE tunnel used to pass IPv6 traffiC. The tunnel ha s not yet been configured on the router.Which of the following commands is not required for the configuration to pass IPv6 traffic?（）
Which of the following are true of both OSPFv2 and OSPFv3?（）