單項選擇題

Network topology exhibit:


Interface VLAN 101 exhibit:


Interface VLAN 102 exhibit: 

Interface VLAN 104 exhibit: 


Interface VLAN 105 exhibit: 

You work as a network technician at. You study the network topology and the other exhibits carefully. Consider the distribution switches 1 and 2. 1 is the primary device for Vlan 101, 102, 105. 2 is the primary device for Vlan 103 and 104 
Note: Please refer to the #2 scenario. 
During routine maintenance, it became necessary to shutdown G1/0/1 on1 and2. 
All other interface were up. During this time,1 became the active device for Vlan104’s HSRP group. As related to Vlan104’s HSRP group. 
What can be done to make the group function properly ?()

A.On 1, disable preempt
B.On 2, decrease the priority value to a value less than 150
C.On 1, increase the decrement value in the track command to a value greater than 6
D.On 1, disable track command.


您可能感興趣的試卷

你可能感興趣的試題

2.單項選擇題

Switch 1 was configured as shown below: 

Based on the output shown above, 
which statement is true?()
 

A.IP traffic matching access list is forwarded through VLANs 5-10.
B.All VLAN traffic in VLANs 5-10 that match access list will be forwarded, and all else will be dropped.
C.IP traffic matching VLAN list 5-10 will be forwarded, and all other traffic will be dropped.
D.All VLAN traffic matching VLAN list 5-10 will be forwarded, and all traffic matching access list is dropped.
E.None of the other alternatives apply

3.單項選擇題

The following was configured on a switch: 
Switch(config) # spanning-tree portfast bpdufilter default 
What is the effect of this configuration command?()

A.If BPDUs are received by a port configured for PortFast, they are ignored and none are sent.
B.The command will enable BPDU filtering on all ports regardless of whether they are configured for BPDU filtering at the interface level.
C.If BPDUs are received by a port configured for Portfast, the port will transition to forwarding state.
D.If BPDUs are received by a port configured for PortFast, then PortFast is disabled and the BPDUs are processed normally.
E.None of the other alternatives apply.

4.多項選擇題

An SVI has been configured on a device. 
Which two statements are true about a switched virtual interface (SVI)?()

A.An SVI is normally created for the default VLAN (VLAN1) to permit remote switch administration.
B.Multiple SVIs can be associated with a VLAN.
C.SVI is another name for a routed port.
D.An SVI is created by entering the no switchport command in interface configuration mode. 
E.An SVI provides a default gateway for a VLAN.

5.多項選擇題

The following output was displayed on a switch. 

Study the exhibit carefully. The administrator is verifying that a CEF FIB entry exists to destination network 192.168.150.0. Given the output generated by the "show ip cef" and "show adjacency detail" commands,
 which three statements are true? ()

A.The "valid cached adjacency" entry indicates that CEF will put all packets going to such an adjacency to the next best switching mode.
B.The number 003071506800 is the MAC address of the source IP address.
C.There is a valid CEF entry for the destination network 192.168.150.0.
D.The number 003071506800 is the MAC address of the 192.168.199.3 next hop IP address.
E.The counters (0 packets, 0 bytes) indicate a problem with the 192.168.199.3 next hop IP address.
F.There is an adjacency for the 192.168.199.3 next hop IP address.

最新試題

Refer to the exhibit. Based on the output of the show spanning-tree command, which statement is true? ()

題型:單項選擇題

Refer to the exhibit. What command was issued on the Layer 3 switch Sw1 between Exhibit #1 and Exhibit #2?()

題型:單項選擇題

Which two statements are true about BPDU port-guard and BPDU filtering?()

題型:多項選擇題

Which router redundancy protocol cannot be configured for interface tracking?()

題型:單項選擇題

Refer to the exhibit. STP has been implemented in the network. Switch SW_A is the root switch for the default VLAN. To reduce the broadcast domain, the network administrator decides to split users on the network into VLAN 2 and VLAN 10. The administrator issues the command spanning-tree vlan 2 root primary on switch SW_A. What will happen as a result of this change?()

題型:單項選擇題

During routine maintenance, G1/0/1 on DS1 was shutdown. All other interface were up. DS2 became the active HSRP device for Vlan101 as desired. However, after G1/0/1 on DS1 was reactivated. DS1 did not become the active HSRP device as desired. What need to be done to make the group for Vlan101 function properly ? ()

題型:單項選擇題

DS2 has not become the active device for Vlan103’s HSRP group even though all interfaces are active. As related to Vlan103’s HSRP group. What can be done to make the group function properly ? ()

題型:單項選擇題

Refer to the exhibit. Switch 15 is configured as the root switch for VLAN 10 but not for VLAN 20. If the STP configuration is correct, what will be true about Switch 15?()

題型:單項選擇題

Refer to the exhibit. Which statement is true about the output?()

題型:單項選擇題

Based on the show spanning-tree vlan 200 output shown in the exhibit, which two statements about the STP process for VLAN 200 are true? ()

題型:多項選擇題