You are installing a cisco 4402 series wireless lan controller.
Which type of interface should you use on the controller’s distribution port？（）
A.1000base-sx sfp
B.10/100/1000 mbps rj45
C.10/100 mbps rj45
D.10000base-sx
您可能感興趣的試卷
你可能感興趣的試題
By default，on the wlan controller for a voice application using cisco 7921 wireless ip phones.
what is the percentage of rf bandwidth that can be dedicated to the phones？（）
A.75 percent
B.85 percent
C.56 percent
D.55 percent
A.clients connected to the rogue access point must be able to connect to the containment controller-based access point.
B.multiple controller-based access points will load-balance the containment task using fewer resources than a single access point.
C.clients connected to the rogue access point may be out of the range of the controller-based access point providing containment.
D.each controller-based access point can handle only a limited amount of clients connected to the rogue access points.
A.c1130-k9w7-tar.boot
B.c1130-k9w7-tar.123-7.ja1.tar
C.c1130-k9w7-tar.default
D.c1130-k9w7-tar.recover
A.problem management
B.configuration management
C.incident management
D.change management
A.technology assessment
B.operations assessment
C.security assessment
D.security administration
E.change management
最新試題
What is the maximum number of wireless controllers that the highest-end Cisco WCS server canmanage？（）
When configuring Cisco Secure ACS to support wireless EAP authentication， which device must be configured as a AAA client？（）
On a WLAN controller， what is the default roaming bandwidth percentage reserved for voice clients？（）
Which of the following parameter sets must be configured on the Cisco Wireless Location Appliance？（）
You have been called upon to add location-based services into an existing controller-basedwireless design which primarily encompasses handheld devices such as barcode scanners and Cisco7920 wireless IP phones.In which mode should you deploy the additional access points to achievethe density required without excessive co-channel interference？（）
You want to dynamically assign users to an 802.1Q VLAN as a result of their authentication. Inorder to accomplish this.Which two IETF RADIUS attributes should you configure on the CiscoSecure ACS？ （）
On a Cisco Aironet 802.11 a/b/g wireless LAN client adapter，the status LED and activity LED are alternating on and off.What does this indicate？（）
A client roams from H-REAP AP1 to H-REAP AP2. The client is unable to associate to H-REAP AP2.H-REAP AP2 has six other clients associated to it， which continue to pass traffic.What has causedthis problem？（）
A Cisco WCS version 4.0 has been installed on a server with a dual Pentium 3.0 GHz processor，4GB RAM， and an 80 GB hard drive. A location appliance has been incorporated into the networkand is being monitored by the Cisco WCS. There are 3000 devices to be tracked but not all of themare being tracked on the Cisco WCS.What can be done to correct the problem？（）
Which of the following commands on the wireless interface of a Cisco 3845 Integrated Service Router allows the SSID to broadcast？（）