A.Transmit only
B.Diversity
C.Receive only
D.Single isolated antenna
您可能感興趣的試卷
你可能感興趣的試題
A.LOS modulation
B.Multipath distortion
C.RF signal absorption
D.RF signal attenuation
E.Fresnel zone impedance
A.Add a new 802.11a WLAN
B.Increase the Layer 2 and Layer 3 security of the WLAN
C.Increase the throughput for the wireless clients
D.Add new services (such as voice) over the WLAN
A.Identify potential problem areas
B.Define intended coverage areas
C.Access compliance with local building codes
D.Determine the final location of APs and antennas
E.Identify sources of RF signal attenuation and RF interference
A.Implementation suggestions
B.Access point locations
C.Security requirements
D.Access point mounting methods
A.Access point received-signal strength level
B.Spectrum utilization
C.Client data rate
D.In-band radio frequency interference
最新試題
In which three frequency bands does the Cisco Spectrum Expert Wi-Fi tool perform spectrumanalysis? ()
How is attenuation measured?()
For an active Cisco Unified Wireless IP Phone 7921G 5 GHz site survey, what are the mostappropriate client test settings to use with the AirMagnet site survey tool?()
What does a broad-spectrum interferer lower?()
Cisco recommends a decibel referenced to 1 milliwatt signal level for the coverage cell edge at thepredetermined data rate that is needed to support the VoWLAN device and call capacityrequirements. What is that signal level value for Cisco Unified Wireless IP Phones 7920, 7921G, and7925G?()
When conducting a wireless voice site survey, which two sizing considerations exist for thecoverage cell?()
What will cause wireless voice devices to perform poorly?()
When planning for VoWLAN capacity during a site survey, how many simultaneous calls can beestimated per 5 GHz channel?()
The Cisco Aironet 1140 Series Access Point draws 12.95 W at the power source. However, whenusing a long Ethernet cable, the device can draw up to how much additional wattage?()
Given the correct input parameters, the Cisco WCS Planning Tool can calculate a recommendedaccess point count for which three uses? ()