A.5 to 10 percent for both 2.4 GHz and 5 GHz
B.10 percent for both 2.4 GHz and 5 GHz
C.20 percent for 2.4 GHz and 15 to 20 percent for 5 GHz
D.20 percent for 2.5 GHz and 10 percent for 5 GHz
您可能感興趣的試卷
你可能感興趣的試題
A.1， 4， 7， 11
B.1， 4， 8. 11
C.1， 6， 11， 1
D.2， 4， 6， 8
A.AP1130
B.AP1242
C.AP1252
D.BR1310
A.Cisco WCS supports third-party antennas for location applications.
B.Access points that are defined with third-party antennas will not participate in rogue on-demand location tracking.
C.Cisco WCS supports third-party antenna gain， azimuth， and elevation progation patterns.
D.Access points that are defined with a third-party antenna in Cisco WCS will display coverage heat maps.
A.Max RF bandwidth is 75 percent， reserved roaming bandwidth is 6 percent.
B.Max RF bandwidth is 50 percent， reserved roaming bandwidth is 10 percent.
C.Max RF bandwidth is 50 percent， reserved roaming bandwidth is 15 percent.
D.Max RF bandwidth is 0 percent， reserved roaming bandwidth is 0.
A.NEMA area
B.plenum area
C.DAS area
D.extended area
E.RF special area
最新試題
Cisco recommends a decibel referenced to 1 milliwatt signal level for the coverage cell edge at thepredetermined data rate that is needed to support the VoWLAN device and call capacityrequirements. What is that signal level value for Cisco Unified Wireless IP Phones 7920， 7921G， and7925G？（）
What will cause wireless voice devices to perform poorly？（）
When planning for VoWLAN capacity during a site survey， how many simultaneous calls can beestimated per 5 GHz channel？（）
When surveying for VoWLAN， which power level should you base the access point coverage designon？（）
When conducting a wireless voice site survey， which two sizing considerations exist for thecoverage cell？（）
Which three items should the site survey documentation include？（）
Which three colors are used in the Cisco WCS v5.2 Voice Readiness Tool？（）
Which format can NOT be imported into Cisco WCS Planning Tool？（）
Which two Cisco antennas provide better isolation from RF sources that might be located behindthe antennas？（）
In an outdoor bridge link， what is calculated by using this formula： transmitter power + antennagain - insertion OR cable loss（）？